From owner-freebsd-stable Sat May 18 22:57:31 2002 Delivered-To: freebsd-stable@freebsd.org Received: from gyros.marcuscom.com (rdu57-17-158.nc.rr.com [66.57.17.158]) by hub.freebsd.org (Postfix) with ESMTP id 7005437B403 for ; Sat, 18 May 2002 22:57:19 -0700 (PDT) Received: from localhost (localhost [127.0.0.1]) by gyros.marcuscom.com (8.12.3/8.12.3) with ESMTP id g4J5utd5069736; Sun, 19 May 2002 01:56:55 -0400 (EDT) (envelope-from marcus@marcuscom.com) Subject: Re: Initial Load of snd_maestro3.ko Causes Page Fault From: Joe Marcus Clarke To: weeguan@myrealbox.com Cc: stable@FreeBSD.ORG In-Reply-To: <20020519132056.A60275@nexus> References: <20020519132056.A60275@nexus> Content-Type: text/plain Content-Transfer-Encoding: 7bit X-Mailer: Ximian Evolution 1.0.5 Date: 19 May 2002 01:56:55 -0400 Message-Id: <1021787815.288.8.camel@gyros.marcuscom.com> Mime-Version: 1.0 Sender: owner-freebsd-stable@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.ORG On Sun, 2002-05-19 at 01:20, weeguan@myrealbox.com wrote: > Hi all, > > I have a DELL Inspiron 4000 that is tracking STABLE. Since around the > time when 4.6PR came out, it has been having this annoying problem of > panicking with a page fault at first boot-up just as the > snd_maestro3.ko module is loaded. > > After the panic and a reboot, everything works fine and dandy. Reboots > are working ok, but cold-boots cause the same thing to happen. > > Attached is uname, dmesg as well as the crashdump. > > Anyone has any ideas what caused this to break? How are you loading the module? I load mine out of loader.conf (the preferred way), and I have no problems. Do you see the same crash if you add the following to /boot/loader.conf: snd_maestro3_load="YES" Joe > > Regards, > Wee Guan. > > -- > Lim, Wee Guan | PGP Fingerprint > weeguan@myrealbox.com | 430F EF64 2C43 A672 67B3 > ICQ: 46537067 | BFE5 6DAA B0C1 E9B1 6332 > > ---- > > FreeBSD localhost 4.6-PRERELEASE FreeBSD 4.6-PRERELEASE #0: Sun May 12 10:44:54 SGT 2002 root@localhost:/usr/obj/usr/src/sys/localhost i386 > ---- > > Copyright (c) 1992-2002 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserved. > FreeBSD 4.6-RC #1: Sun May 19 09:59:57 SGT 2002 > weeguan@localhost:/usr/obj/usr/src/sys/localhost > Timecounter "i8254" frequency 1193182 Hz > CPU: Pentium III/Pentium III Xeon/Celeron (651.48-MHz 686-class CPU) > Origin = "GenuineIntel" Id = 0x686 Stepping = 6 > Features=0x383f9ff > real memory = 201244672 (196528K bytes) > avail memory = 192282624 (187776K bytes) > Preloaded elf kernel "kernel" at 0xc035d000. > Pentium Pro MTRR support enabled > Using $PIR table, 9 entries at 0xc00fbd80 > apm0: on motherboard > apm: found APM BIOS v1.2, connected at v1.2 > npx0: on motherboard > npx0: INT 16 interface > pcib0: on motherboard > pci0: on pcib0 > pcib1: at device 1.0 on pci0 > pci1: on pcib1 > pci1: at 0.0 irq 11 > pcic0: irq 11 at device 3.0 on pci0 > pcic0: PCI Memory allocated: 0x44000000 > pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][FUNC pci int + CSC serial isa irq] > pccard0: on pcic0 > pcic1: irq 11 at device 3.1 on pci0 > pcic1: PCI Memory allocated: 0x44001000 > pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][FUNC pci int + CSC serial isa irq] > pccard1: on pcic1 > isab0: at device 7.0 on pci0 > isa0: on isab0 > atapci0: port 0x860-0x86f at device 7.1 on pci0 > ata0: at 0x1f0 irq 14 on atapci0 > ata1: at 0x170 irq 15 on atapci0 > uhci0: port 0xdce0-0xdcff irq 11 at device 7.2 on pci0 > usb0: on uhci0 > usb0: USB revision 1.0 > uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > uhub0: 2 ports with 2 removable, self powered > chip1: port 0x840-0x84f at device 7.3 on pci0 > pci0: (vendor=0x125d, dev=0x1998) at 8.0 irq 5 > xl0: <3Com 3c556 Fast Etherlink XL> port 0xd400-0xd4ff mem 0xfbffd800-0xfbffd87f,0xfbffdc00-0xfbffdc7f irq 11 at device 16.0 on pci0 > xl0: Ethernet address: 00:01:03:84:8a:09 > miibus0: on xl0 > ukphy0: on miibus0 > ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > pci0: (vendor=0x10b7, dev=0x1007) at 16.1 irq 11 > orm0: