Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 29 Dec 2003 12:40:06 +1000
From:      anubis <anubis357@optusnet.com.au>
To:        danl@solvnet.net, freebsd-questions@freebsd.org
Subject:   Re: 4.9, 5.1 boot failure after install
Message-ID:  <200312291240.06676.anubis357@optusnet.com.au>
In-Reply-To: <3FEC133C.11489.27764D@localhost>
References:  <3FEC133C.11489.27764D@localhost>

next in thread | previous in thread | raw e-mail | index | archive | help
On Sat, 27 Dec 2003 02:53 am, danl@solvnet.net wrote:
> Hello,
>
> I had 4.9 release working and did a clean install of 5.1 release over
> the 4.9 and ended up with boot failure after install. Using allBSD
> partition and standard MBR I get a missing operating system error. If I
> use the FreeBSD boot I just get "default F1" and a beep. Now trying to
> install the 4.9 gives the same results.
>
> I'm using a Mylex DAC960ptl (accelraid 250) with the primary disk
> setup as JBOD. I set the bootable disk as active but everytime I go
> back to config fdisk the flag is not set.
>
> I then upgraded and flashed the RAID card, reformatted the disks and
> tried a 4.9 install, again with the same results.
>
> Is there an issue with the DAC card geometry or BIOS? Or a subtle
> quirk that isn't documented yet?
>
> thanks,
> Dan
>
> _______________________________________________
> freebsd-questions@freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-questions
> To unsubscribe, send any mail to
> "freebsd-questions-unsubscribe@freebsd.org"

I have had a similar problem.  I also couldnt get it to make the system 
bootable using the install cd.  I got around it by using the live filesystem 
cd.  I dont know how that they are different but it seemed to write out the 
changes when I asked not like as in the install disk.




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200312291240.06676.anubis357>