Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 5 Feb 2009 18:38:09 +0100
From:      "Paul B. Mahol" <onemda@gmail.com>
To:        Lars Lonne <lonnelars@gmail.com>
Cc:        freebsd-questions@freebsd.org
Subject:   Re: No wifi signal with usb antenna (rum driver)
Message-ID:  <3a142e750902050938g7f57a244jb85e30f9eeca6200@mail.gmail.com>
In-Reply-To: <baa313a90902050921x25d812a7i5da9aaaf0c12d336@mail.gmail.com>
References:  <baa313a90902040938y75ea600dxc403df3608f97a4f@mail.gmail.com> <3a142e750902050618l1736032bue8c2a21da7e73d52@mail.gmail.com> <baa313a90902050921x25d812a7i5da9aaaf0c12d336@mail.gmail.com>

next in thread | previous in thread | raw e-mail | index | archive | help
On 2/5/09, Lars Lonne <lonnelars@gmail.com> wrote:
> 2009/2/5 Paul B. Mahol <onemda@gmail.com>:
>> On 2/4/09, Lars Lonne <lonnelars@gmail.com> wrote:
>>> Hi all. I have recently installed FreeBSD-7.1-RELEASE on my Compaq Evo
>>> laptop. It used to dualboot with windows xp and gentoo linux, but I
>>> decided to give FreeBSD a try instead, so now it dualboots with
>>> windows and FreeBSD. My biggest problem is connecting to the internet
>>> over the local wifi network. I am using a usb antenna, which uses the
>>> rum driver in FreeBSD. When using windows, the signal strength is low
>>> (I am located quite far from the access point), but works fine. I can
>>> connect to the network and get on the internet, no problem. Problem is
>>> when I start FreeBSD, I cannot get a signal, i.e. ifconfig always
>>> reports "no carrier". I can connect to the network with FreeBSD if I
>>> move closer to the AP, but it is impractical for me to do so.
>>>
>>> Has anyone experienced anything similar, or know what could be causing
>>> it? Please let me know if you need more information. Hope you can help
>>> me.
>>>
>>> /lars
>>> _______________________________________________
>>> freebsd-questions@freebsd.org mailing list
>>> http://lists.freebsd.org/mailman/listinfo/freebsd-questions
>>> To unsubscribe, send any mail to
>>> "freebsd-questions-unsubscribe@freebsd.org"
>>>
>>
>> This is known "rum" issue, some code is missing.
>>
>> I debuged it some time ago, but with no luck.
>> I will try again some time later ....
>>
>> --
>> Paul
>>
>
> Thank you for your reply. I have the same problem with the ral driver
> (as I mentioned in an earlier email to this mailing list) when I am
> using a different antenna (a pc-card). Is this also a known issue with
> the ral driver?

If on linux(open source driver, not via ndiswrapper) you do not have
such problem, than it is ral driver fault.

-- 
Paul



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3a142e750902050938g7f57a244jb85e30f9eeca6200>