Opcode Prefixes
---------------

   Opcode prefixes are used to modify the following opcode.  They are
used to repeat string instructions, to provide section overrides, to
perform bus lock operations, and to give operand and address size
(16-bit operands are specified in an instruction by prefixing what would
normally be 32-bit operands with a "operand size" opcode prefix).
Opcode prefixes are usually given as single-line instructions with no
operands, and must directly precede the instruction they act upon.  For
example, the `scas' (scan string) instruction is repeated with:
     	repne
     	scas

   Here is a list of opcode prefixes:

   * Section override prefixes `cs', `ds', `ss', `es', `fs', `gs'.
     These are automatically added by specifying using the
     SECTION:MEMORY-OPERAND form for memory references.

   * Operand/Address size prefixes `data16' and `addr16' change 32-bit
     operands/addresses into 16-bit operands/addresses.  Note that
     16-bit addressing modes (i.e. 8086 and 80286 addressing modes) are
     not supported (yet).

   * The bus lock prefix `lock' inhibits interrupts during execution of
     the instruction it precedes.  (This is only valid with certain
     instructions; see a 80386 manual for details).

   * The wait for coprocessor prefix `wait' waits for the coprocessor
     to complete the current instruction.  This should never be needed
     for the 80386/80387 combination.

   * The `rep', `repe', and `repne' prefixes are added to string
     instructions to make them repeat `%ecx' times.