Continuing at a different address
=================================

   Ordinarily, when you continue your program, you do so at the place
where it stopped, with the `continue' command.  You can instead
continue at an address of your own choosing, with the following
commands:

`jump LINESPEC'
     Resume execution at line LINESPEC.  Execution stops again
     immediately if there is a breakpoint there.  *Note Printing source
     lines: List, for a description of the different forms of LINESPEC.

     The `jump' command does not change the current stack frame, or the
     stack pointer, or the contents of any memory location or any
     register other than the program counter.  If line LINESPEC is in a
     different function from the one currently executing, the results
     may be bizarre if the two functions expect different patterns of
     arguments or of local variables.  For this reason, the `jump'
     command requests confirmation if the specified line is not in the
     function currently executing.  However, even bizarre results are
     predictable if you are well acquainted with the machine-language
     code of your program.

`jump *ADDRESS'
     Resume execution at the instruction at address ADDRESS.

   You can get much the same effect as the `jump' command by storing a
new value into the register `$pc'.  The difference is that this does
not start your program running; it only changes the address of where it
*will* run when you continue.  For example,

     set $pc = 0x485

makes the next `continue' command or stepping command execute at
address `0x485', rather than at the address where your program stopped.
See Continuing and stepping: Continuing and Stepping.

   The most common occasion to use the `jump' command is to back up-
perhaps with more breakpoints set-over a portion of a program that has
already executed, in order to examine its execution in more detail.