Skip site navigation (1)Skip section navigation (2)
Date:      Sat, 24 Mar 2007 20:53:14 -0500
From:      "Nikolas Britton" <>
To:        "Jan Mikkelsen" <>
Cc:        FreeBSD Stable <>,, Phillip Neumann <>,
Subject:   Re: Amd64 Unstable Areca
Message-ID:  <>
In-Reply-To: <000201c76e68$b5339820$0502a8c0@IBMA618C20271E>
References:  <> <000201c76e68$b5339820$0502a8c0@IBMA618C20271E>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
On 3/24/07, Jan Mikkelsen <> wrote:
> Hi,
> Nikolas Britton wrote:
> > If that doesn't work move back down to
> >
> I could consistently make corrupt data.  If you are going to go
> back, that's probably a bad choice. didn't seem to have
> corruption problems.

The driver I pointed to was a custom hack I did for my
servers, It worked fine for the 7 months I was using it... I'm
assuming we're talking about I/O load, the servers rarely see high cpu
loads... the hardware:

arcmsr0: <Areca SATA Host Adapter RAID Controller (RAID6 capable)
ARECA RAID ADAPTER0: Driver Version 2006-8-18
pass1 at arcmsr0 bus 0 target 16 lun 0
pass1: <Areca RAID controller R001> Fixed Processor SCSI-0 device
da0 at arcmsr0 bus 0 target 0 lun 0
da0: <Areca ARC-1220-VOL#00 R001> Fixed Direct Access SCSI-3 device
da0: 166.666MB/s transfers (83.333MHz, offset 32, 16bit), Tagged
Queueing Enabled
da0: 1430511MB (2929687040 512 byte sectors: 255H 63S/T 182364C)

I just upgraded them for the DST change.  :-/

Want to link to this message? Use this URL: <>