Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 17 Jun 2020 17:19:51 -0700
From:      Pete Wright <>
Subject:   Re: very slow - WCPU
Message-ID:  <>
In-Reply-To: <>
References:  <>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help

On 6/17/20 4:44 PM, ajtiM via freebsd-questions wrote:
> Hi!
> For whatever reason after few last updates I cannot use FreeCAD (WCPU
> 99,7%), Cura (3D printing) - WCPU time is good for cura-engine but
> Python 3.7 is 100.22% and Blender stop working because "Error!
> Unsupported graphics card or driver. A graphics card and driver with
> support for OpenGL 3.3 or higher is required. The program will now
> close."

Can you provide information on which graphics card you are using, and if 
you have installed/configured the appropriate drivers?  That will most 
likely help people here better answer you question.


Pete Wright

Want to link to this message? Use this URL: <>