From owner-freebsd-questions Mon Apr 15 09:18:37 1996 Return-Path: owner-questions Received: (from root@localhost) by freefall.freebsd.org (8.7.3/8.7.3) id JAA00944 for questions-outgoing; Mon, 15 Apr 1996 09:18:37 -0700 (PDT) Received: from mail06.mail.aol.com (mail06.mail.aol.com [152.163.172.108]) by freefall.freebsd.org (8.7.3/8.7.3) with SMTP id JAA00939 for ; Mon, 15 Apr 1996 09:18:35 -0700 (PDT) From: MansurKhan@aol.com Received: by mail06.mail.aol.com (8.6.12/8.6.12) id MAA19685 for questions@freebsd.org; Mon, 15 Apr 1996 12:17:59 -0400 Date: Mon, 15 Apr 1996 12:17:59 -0400 Message-ID: <960415121758_470258011@mail06> To: questions@freebsd.org Subject: CD-ROM Sender: owner-questions@freebsd.org X-Loop: FreeBSD.org Precedence: bulk Hi, I have a Gateway 2000 DX2-50 system with an Acculogic EIDE card (sIDE-2/VL). The card supports four IDE devices on a primary and secondary port. Currently it is setup with an IRQ of 14 and adress of 1F0 for the primary and an IRQ of 15 and an address of 170 for the secondary. I have two hard drives on the primary port and a Sony CSD 760E CD-ROM on the secondary port. After a minimal install on the hard drive, during boot up the first time it found the wdc0 and wdc1 ports with the correct IRQs and addresses. But it was looking for the scd0 @ 0x230 which it did not find. So I used the Userconfig utility to change the scd0 address to 170. It still did not find scd0 there and it could not find wdc1 anymore. After I set scd0 back to 230 (and rebooted ofcourse) it still cannot find either wdc1 or scd0. It does find both hard drives OK though. How do I get it to recognize the CD-ROM? Thanking you in advance for your prompt help. Mansur Khan.