Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 17 Dec 2003 19:55:13 +0200
From:      Ion-Mihai Tetcu <>
To:        "Admin" <>
Cc:        freebsd-questions@FreeBSD.ORG
Subject:   Re: FreeBSD 5.1 PowerPak Installation problem
Message-ID:  <>
In-Reply-To: <000101c3c4ab$54c78740$1c77fea9@dpc27>
References:  <000101c3c4ab$54c78740$1c77fea9@dpc27>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
On Wed, 17 Dec 2003 14:36:21 -0000
"Admin" <> wrote:

> Dear sir/ madam,

Please warp.
> The FreeBSD 5.1 PowerPak was purchased from FreeBSD Mall Ref Invoice
> No: 3120119. This package has been ordered to develop a FreeBSD Driver
> for PCI Bus Interface. When tried installing, on Pentium P4 2.53GHz,
> the installation fails during installing the package on to the hard
> disc, displaying message e.g. Extracting base into / dir, Panic
> ufs_dirbad: bad dir and ask to reboot the system. After several
> attempts, I have managed to install the minimum installation.

Please post the output of dmesg and your hardawe. We can say anything
without knowing your hardware.

> I have tried installing on a Pentium Pro 300MHz PC and it won't let me
> configure the X. 

Both proc fully supported.

> When I try to configure the X, the system starts
> rebooting. Would you kindly advise, what should I do?

Did you make any world /kernel build & install ?
Try configuring using xf86config instead of xf86cfg. Give more details.
> I have very tight requirement. I need to develop the driver and supply
> to the customer by end of January 2004.

Good luck.
> Is this software fully installable? 

Yes. It sould. I'm running it ;)

> If not, would you please send me the updated software a.s.a.p.
> Would you please advise a.s.a.p.

Note that you are posting to a comunity mailling list. Also note that
The Freebsd Project and The FreeBSD Foundation is not responsable for
FreeBSD Mall which is a third party.

Also note that I'm not speaking for either of them.

Unregistered ;) FreeBSD user

Want to link to this message? Use this URL: <>