Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 22 Jul 2003 10:00:33 -0700 (PDT)
From:      "Dominik Brettnacher" <dominik.brettnacher@teresto.net>
To:        freebsd-bugs@FreeBSD.org
Subject:   Re: kern/50683: fxp broken
Message-ID:  <200307221700.h6MH0Xbq075040@freefall.freebsd.org>

next in thread | raw e-mail | index | archive | help
The following reply was made to PR kern/50683; it has been noted by GNATS.

From: "Dominik Brettnacher" <dominik.brettnacher@teresto.net>
To: freebsd-gnats-submit@FreeBSD.org, roar.pettersen@it.uib.no
Cc:  
Subject: Re: kern/50683: fxp broken
Date: Tue, 22 Jul 2003 18:47:26 +0200

 I have the same problems on an SMP-machine with two fxp cards: it works
 for a few days without a flaw, then more or less suddenly, the kernel says
 fxp{0,1}: device timeout. Only a reboot helps to reanimate the NIC:
 
 Copyright (c) 1992-2003 The FreeBSD Project.
 Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
 	The Regents of the University of California. All rights reserved.
 FreeBSD 4.8-RELEASE #0: Sat May 17 21:59:26 CEST 2003
     domi@rennix.teresto.net:/usr/src/sys/compile/RENNIX
 Timecounter "i8254"  frequency 1193182 Hz
 CPU: Intel Pentium III (730.80-MHz 686-class CPU)
   Origin = "GenuineIntel"  Id = 0x683  Stepping = 3
  
 Features=0x383fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
 real memory  = 1610547200 (1572800K bytes)
 avail memory = 1561874432 (1525268K bytes)
 Programming 24 pins in IOAPIC #0
 IOAPIC #0 intpin 2 -> irq 0
 FreeBSD/SMP: Multiprocessor motherboard
  cpu0 (BSP): apic id:  0, version: 0x00040011, at 0xfee00000
  cpu1 (AP):  apic id:  1, version: 0x00040011, at 0xfee00000
  io0 (APIC): apic id:  2, version: 0x00170011, at 0xfec00000
 Preloaded elf kernel "kernel" at 0xc0521000.
 Pentium Pro MTRR support enabled
 md0: Malloc disk
 Using $PIR table, 8 entries at 0xc00f7220
 npx0: <math processor> on motherboard
 npx0: INT 16 interface
 pcib0: <Host to PCI bridge> on motherboard
 IOAPIC #0 intpin 18 -> irq 2
 IOAPIC #0 intpin 17 -> irq 16
 pci0: <PCI bus> on pcib0
 agp0: <VIA 82C691 (Apollo Pro) host to PCI bridge> mem
 0xe0000000-0xe07fffff at device 0.0 on pci0
 pcib1: <VIA 82C598MVP (Apollo MVP3) PCI-PCI (AGP) bridge> at device 1.0 on
 pci0
 IOAPIC #0 intpin 16 -> irq 17
 pci1: <PCI bus> on pcib1
 pci1: <ATI Mobility-1 graphics accelerator> at 0.0 irq 17
 isab0: <VIA 82C686 PCI-ISA bridge> at device 7.0 on pci0
 isa0: <ISA bus> on isab0
 atapci0: <VIA 82C686 ATA66 controller> port 0xffa0-0xffaf at device 7.1 on
 pci0
 ata0: at 0x1f0 irq 14 on atapci0
 ata1: at 0x170 irq 15 on atapci0
 pci0: <unknown card> (vendor=0x1106, dev=0x3057) at 7.4
 fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xd800-0xd83f mem
 0xdffc0000-0xdffdffff,0xdfffe000-0xdfffefff irq 2 at device 10.0 on pci0
 fxp0: Ethernet address 00:02:b3:27:37:22
 inphy0: <i82555 10/100 media interface> on miibus0
 inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
 fxp1: <Intel Pro 10/100B/100+ Ethernet> port 0xdc00-0xdc3f mem
 0xdfe00000-0xdfefffff,0xdffff000-0xdfffffff irq 16 at device 13.0 on pci0
 fxp1: Ethernet address 00:90:27:50:2d:f2
 inphy1: <i82555 10/100 media interface> on miibus1
 inphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
 orm0: <Option ROMs> at iomem 0xc0000-0xcefff,0xcf000-0xcffff on isa0
 fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
 fdc0: FIFO enabled, 8 bytes threshold
 fd0: <1440-KB 3.5" drive> on fdc0 drive 0
 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
 kbd0 at atkbd0
 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
 sc0: <System console> at flags 0x100 on isa0
 sc0: VGA <16 virtual consoles, flags=0x300>
 sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
 sio0: type 16550A
 sio1 at port 0x2f8-0x2ff irq 3 on isa0
 sio1: type 16550A
 ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
 ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
 ppc0: FIFO with 16/16/8 bytes threshold
 plip0: <PLIP network interface> on ppbus0
 lpt0: <Printer> on ppbus0
 lpt0: Interrupt-driven port
 ppi0: <Parallel I/O> on ppbus0
 APIC_IO: Testing 8254 interrupt delivery
 APIC_IO: routing 8254 via IOAPIC #0 intpin 2
 SMP: AP CPU #1 Launched!
 ad0: 117800MB <ASI ARAID99 1000 Ver1.00> [239340/16/63] at ata0-master
 UDMA66
 Mounting root from ufs:/dev/ad0s1a
 



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200307221700.h6MH0Xbq075040>