Date: Wed, 12 Nov 2003 09:21:06 +0200 From: John Hay <jhay@icomtek.csir.co.za> To: jhb@freebsd.org Cc: current@freebsd.org Subject: Re: panic: probing for non-PCI bus Message-ID: <20031112072105.GA17303@zibbi.icomtek.csir.co.za> In-Reply-To: <20031112070125.GB16030@zibbi.icomtek.csir.co.za> References: <20031111203859.GA97150@zibbi.icomtek.csir.co.za> <XFMail.20031111163750.jhb@FreeBSD.org> <20031112070125.GB16030@zibbi.icomtek.csir.co.za>
next in thread | previous in thread | raw e-mail | index | archive | help
Oops, I missed a not. On Wed, Nov 12, 2003 at 09:01:25AM +0200, John Hay wrote: > > > Hmmm, I'll have to open it up to see if it has an AGP slot, but it is in > > > the server room at work. :-/ Here is a dmesg with a kernel of about Nov 3. > > > > > > pcib1: <PCI-PCI bridge> at device 1.0 on pci0 > > > pci1: <PCI bus> on pcib1 > > > > Ok, no AGP bus, but you do have a PCI bus that the MP Table doesn't know about. > > I'll commit a fix. Note that your system isn't going to work with ACPI. Perhaps > > there is a BIOS option to set the interrupt model to APIC rather than PIC that > > might fix the ACPI case. > > Ok, I opened the machine this morning and it does have an AGP slot. > > I also had a look in the BIOS setup, but didn't see anything to change > the interrupt model. The closest I saw was: > > MPS 1.4 Support - Enabled/Disabled (Enabled) > PCI 2.1 Support - Enabled/disabled (Enabled) > PNP OS Installed - No/Yes (No) > > I built a new kernel with your mptable changes included and with acpi > enabled, it would panic, but the onboard scsi interrupt doesn't work, ^^^ not > so you don't get very far. With acpi disabled, it seems to work fine, > although I haven't done much yet. So it looks like I'm up and running > again, thanks. John -- John Hay -- John.Hay@icomtek.csir.co.za / jhay@FreeBSD.org
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20031112072105.GA17303>