Date: Thu, 19 Aug 1999 22:17:42 +0200 From: "Holger van Koll" <Holger@vanKoll.de> To: <freebsd-questions@freebsd.org> Subject: ed1 insted of ed0... Message-ID: <016601beea7f$e4f721a0$0a00a8c0@holler.localdomain>
next in thread | raw e-mail | index | archive | help
Setup: FreeBSD 3.2, installed via FTP today. NE2000 PCI-Ethernetcard (Realtek 8029) Problem: At boot-time I get ed1: <NE2000 PCI Ethernet (RealTek 8029)> rev 0x00 int a irq 3 on pci0.9.0 ed1: address 00:40:05:65:15:5b, type NE2000 (16 bit) Fine so far, but why is ed1 instead of ed0 assigned? If I add device ed0 at isa port 0xb000 net irq 11 iomem 0xd8000 to my kernel-config and en ed0 po ed0 0xd000 ir ed0 3 iom ed0 0xd8000 f ed0 0 q to /boot/kernel.conf (where is doku about that???) then I also get ed0 at 0xd000-0xd01f irq 11 on eisa slot 13 ed0: address 00:40:05:65:15:5b, type NE2000 (16 bit) later in the boot-process (it finds the same card 2 x). However, only ed1 is RUNNING (ifconfig) ; flags=8802 (ed0) ; 8843 (ed1). What is going on here? How can I tell the kernel to assign ed0 ? Furthermore I got many errors on startup after installing like real memory = 134217728 (131072K bytes) config> di zp0 No such device: zp0 Invalid command or syntax. Type `?' for help. config> di ze0 No such device: ze0 Invalid command or syntax. Type `?' for help. I just removed all those lines in /boot/kernel.config and the errors were gone. Anything to note here? To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?016601beea7f$e4f721a0$0a00a8c0>