Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 17 Nov 2000 19:23:34 -0500 (EST)
From:      Jim Weeks <jim@siteplus.net>
To:        joseph@randomnetworks.com
Cc:        stable@FreeBSD.ORG
Subject:   Re: 4.2 Beta hang on warm boot
Message-ID:  <Pine.BSF.4.21.0011171914520.503-100000@veager.siteplus.net>
In-Reply-To: <Pine.BSF.4.21.0011171031350.1026-100000@rodan.water-programs.com>

next in thread | previous in thread | raw e-mail | index | archive | help
I had a simular situation on an old 486.  I wish I had kept all the
output, but as best I can remember the problem stemmed from ed0 not being
able to clear shared memory on reboot.  I did keep this line.

ed0: failed to clear shared memory at d8000 - check configuration

Of course you are not getting this far during reboot. Maybe someone with
more knowledge can pick up the ball here.

Possibly, configuring ed0 in the kernel rather than in /boot/kernel.conf
would solve the problem.

--
Jim Weeks


On Fri, 17 Nov 2000 joseph@randomnetworks.com wrote:

> 
> 	I dug up an old 486 in hopes that I could get 4.2-BETA from 11/15
> to install on it and use it as a firewall for my cable connection at
> home.  Everything went nicely until that first reboot after the
> install.  It hung when it hit the ISA bus.  I thought this was odd, so I
> turned off the power and then fired it back up.  It then booted fine.  So
> I did a shutdown -r now to see what would happen.  It hung on the ISA bus
> during boot again.  Once again I turned off the power and it booted fine
> after powering it back on.
> 
> 	So from this, 4.2-BETA from 11/15 will not warm boot (reboot),
> stopping on the ISA bus.  I've attached the dmesg output from a cold boot
> and marked the line that it stops at during a warm boot.
> 
> 	Any ideas on what's happening here?
> 
> --------------------------------------------------------------------
> | Joseph Scott                       The Office Of Water Programs  |
> | joseph@randomnetworks.com          joseph.scott@owp.csus.edu     |
> --------------------------------------------------------------------
> 
> Copyright (c) 1992-2000 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
>         The Regents of the University of California. All rights reserved.
> FreeBSD 4.2-20001115-BETA #0: Wed Nov 15 12:57:10 GMT 2000
>     root@usw3.freebsd.org:/usr/src/sys/compile/GENERIC
> Timecounter "i8254"  frequency 1193182 Hz
> CPU: i486 DX2 (486-class CPU)
>   Origin = "GenuineIntel"  Id = 0x435  Stepping = 5
>   Features=0x3<FPU,VME>
> real memory  = 25427968 (24832K bytes)
> config> di psm0
> config> di sn0
> config> di lnc0
> config> di ie0
> config> di fe0
> config> di cs0
> config> di bt0
> config> di aic0
> config> di aha0
> config> di adv0
> config> en ed0
> config> po ed0 0x300
> config> ir ed0 5
> config> iom ed0 0xd8000
> config> f ed0 0
> config> q
> avail memory = 20652032 (20168K bytes)
> Preloaded elf kernel "kernel" at 0xc0436000.
> Preloaded userconfig_script "/boot/kernel.conf" at 0xc043609c.
> md0: Malloc disk
> npx0: <math processor> on motherboard
> npx0: INT 16 interface
> isa0: <ISA bus> on motherboard ********* !! Dies here on warm boot !! **
> fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
> fdc0: FIFO enabled, 8 bytes threshold
> fd0: <1440-KB 3.5" drive> on fdc0 drive 0
> ata0: mask=03 status0=50 status1=00
> ata0: mask=03 ostat0=50 ostat2=00
> ata0-master: ATAPI probe a=00 b=00
> ata0-slave: ATAPI probe a=00 b=00
> ata0: mask=03 status0=50 status1=00
> ata0-master: ATA probe a=01 b=a5
> ata0: devices=01
> ata0 at port 0x1f0-0x1f7,0x3f6 irq 14 on isa0
> ata1: mask=00 status0=ff status1=ff
> atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
> atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
> kbd0 at atkbd0
> vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
> sc0: <System console> at flags 0x100 on isa0
> sc0: VGA <16 virtual consoles, flags=0x300>
> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
> sio0: type 16550A
> sio1: configured irq 3 not in bitmap of probed irqs 0
> ppc0: cannot reserve I/O port range
> ed0 at port 0x300-0x31f iomem 0xd8000 irq 5 drq 0 on isa0
> ed0: address 00:c0:f0:09:eb:b6, type NE2000 (16 bit) 
> ad0: 325MB <QUANTUM LPS340A> [1011/15/44] at ata0-master BIOSPIO
> Mounting root from ufs:/dev/ad0s1a
> 
> 
> 
> 
> To Unsubscribe: send mail to majordomo@FreeBSD.org
> with "unsubscribe freebsd-stable" in the body of the message
> 



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.21.0011171914520.503-100000>