From owner-freebsd-bugs Wed Mar 29 07:41:36 1995 Return-Path: bugs-owner Received: (from majordom@localhost) by freefall.cdrom.com (8.6.10/8.6.6) id HAA27621 for bugs-outgoing; Wed, 29 Mar 1995 07:41:36 -0800 Received: from mpp.com (dialup-2-151.gw.umn.edu [134.84.101.151]) by freefall.cdrom.com (8.6.10/8.6.6) with ESMTP id HAA27578 for ; Wed, 29 Mar 1995 07:41:30 -0800 Received: (from mpp@localhost) by mpp.com (8.6.11/8.6.9) id EAA00389; Wed, 29 Mar 1995 04:57:13 -0600 From: Mike Pritchard Message-Id: <199503291057.EAA00389@mpp.com> Subject: Re: kern/280: new slice manager totally confused about old slice disks To: bde@zeta.org.au (Bruce Evans) Date: Wed, 29 Mar 1995 04:57:12 -0600 (CST) Cc: freebsd-bugs@freefall.cdrom.com In-Reply-To: <199503290712.RAA20923@godzilla.zeta.org.au> from "Bruce Evans" at Mar 29, 95 05:12:22 pm X-Mailer: ELM [version 2.4 PL24] MIME-Version: 1.0 Content-Type: text/plain; charset=US-ASCII Content-Transfer-Encoding: 7bit Content-Length: 1696 Sender: bugs-owner@FreeBSD.org Precedence: bulk > > Subject: Re: kern/280: new slice manager totally confused about old slice dis > > Try copying the new MAKEDEV over and doing a ./MAKEDEV sd0, then try: > > > > mount -t msdos /dev/sd0s1 /dos > > > > Assuming, of course, that slice 1 is the DOS partition. This is > > Not a good assumption. There may be up to 26 DOS partitions starting > as late as slice s4 (primary partition #4, extended partition #3 > containing 25 more). Very few setups will have this, but the install > program has to be careful not to break it (if not support it), and > people answering bug reports should know about it. > OK, after finally seeing some mail mentioning that I needed to run the new MAKEDEV to create the /dev/sd#s# devices I was finally able to mount my MS-DOS paritition I have on my sd0 drive again . I still can't mount the two partitions I have on my sd1 disk. My sd1 disk is fdisked as follows: 500MB for DOS within this paritition are two extended/logical DOS partitions, which are my DOS D/E drives. 500MB for FreeBSD Before all of the slicing code I was able to create entries in my disk label with the correct start/end locations so I could mount the D/E DOS drives under FreeBSD. After running the new MAKEDEV and attempting to mount every /dev/{sd1*,sd1s*} device, I was unable to mount either paritition. An fdisk on /dev/sd1s1 shows an entry that would be the D/E logical DOS partitions. fdisk sd1s2 shows my FreeBSD paritition, which is what I would expect. So my question is, with the new slice code, how do I mount these two parititions again. -- Mike Pritchard pritc003@maroon.tc.umn.edu "Go that way. Really fast. If something gets in your way, turn"