From owner-freebsd-hardware Fri Aug 2 23:48:33 1996 Return-Path: owner-hardware Received: (from root@localhost) by freefall.freebsd.org (8.7.5/8.7.3) id XAA05521 for hardware-outgoing; Fri, 2 Aug 1996 23:48:33 -0700 (PDT) Received: from Kryten.nina.com (dyn051-gnv.51.fdt.net [205.229.51.52]) by freefall.freebsd.org (8.7.5/8.7.3) with ESMTP id XAA05499 for ; Fri, 2 Aug 1996 23:48:17 -0700 (PDT) Received: from localhost (frankd@localhost) by Kryten.nina.com (8.7.5/8.6.12) with SMTP id CAA23289; Sat, 3 Aug 1996 02:44:14 -0400 (EDT) X-Authentication-Warning: Kryten.nina.com: frankd owned process doing -bs Date: Sat, 3 Aug 1996 02:44:13 -0400 (EDT) From: Frank Seltzer X-Sender: frankd@Kryten.nina.com To: "Rodney W. Grimes" cc: freebsd-hardware@freebsd.org Subject: Re: Parity errors during install In-Reply-To: <199608030637.XAA03798@GndRsh.aac.dev.com> Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-hardware@freebsd.org X-Loop: FreeBSD.org Precedence: bulk On Fri, 2 Aug 1996, Rodney W. Grimes wrote: > Built in yes, enabled by default on the 2940 (it's easy enough to check > this one, it is right in the SCSIselect menus), disabled by default > on the MC4421 (the manual is wrong, everyone of these I have seen comes > with the termination disabled). W4 should be installed to enable termination, > just in case you don't have the manual handy. Right now I have jumpers on; W4 - Interface termination W3 - +5v to bus W1 - Term power from drive Is this correct? > Rod Grimes rgrimes@gndrsh.aac.dev.com > Accurate Automation Company Reliable computers for FreeBSD > Frank -- Only in America can a homeless veteran sleep in a cardboard box while a draft dodger sleeps in the White House.