Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 14 Dec 2015 13:59:17 -0800
From:      Charles Swiger <cswiger@mac.com>
To:        Bryan Albright <bryana@darth-vader.org>
Cc:        FreeBSD - <freebsd-questions@freebsd.org>
Subject:   Re: Upgrade question?
Message-ID:  <64EF16E4-3992-40A1-B9E9-1238DEE0F6F3@mac.com>
In-Reply-To: <20151214204949.GA27984@darth-vader.org>
References:  <20151214204949.GA27984@darth-vader.org>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
On Dec 14, 2015, at 12:49 PM, Bryan Albright <bryana@darth-vader.org> wrote:
> Hi folks!
> 
> When upgrading from 8.4 to 9.3,in preparation to go from 9.3 to 10.2,
> does it make sense to do a full port upgrade, after checking
> /usr/ports/UPDATING (of course?)
> 
> Something like a 
> % portupgrade -a
> 
> Between the update to 9.3 and the update to 10.2?  Or can I "get away
> with" a update from 8.4 to 9.3, then update 9.3 to 10.2, then doa
> portupgrade -a?

Are you stopping at 9.3 for a while, or are you moving to 10.2 immediately?

If you're going to run 9.3 for a while, it's reasonable to recompile the
list of ports for that version.  Otherwise, leave it be until after
you've updated to 10.2.

> (and I'm open to a "better" method of upgrading ports - I've just been
> using a script to do the portupgrade since 2.2)

You might find it cleaner to keep a list of ports you had installed,
(ie, a backup), do a clean install of 10.2, and then reinstall only
the ports which you know you want.  Restore the ports config and
anything else under /usr/local/etc which you want to keep around.

Some of the older ports you had might not be needed anymore-- ie,
build time deps, stuff which has been integrated or modernized from
the base FreeBSD, etc.

Regards,
-- 
-Chuck




Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?64EF16E4-3992-40A1-B9E9-1238DEE0F6F3>