Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 14 Jun 2004 16:27:15 -0700
From:      Kris Kennaway <kris@obsecurity.org>
To:        qa@FreeBSD.org
Subject:   [spam_if_you_want_to@yahoo.co.uk: unattended install of FreeBSD 5.2.1 does not umount disk properly]
Message-ID:  <20040614232715.GA98586@xor.obsecurity.org>

next in thread | raw e-mail | index | archive | help
----- Forwarded message from Richard Smith <spam_if_you_want_to@yahoo.co.uk> -----

X-Original-To: kkenn@localhost
Delivered-To: kkenn@localhost.obsecurity.org
Delivered-To: kris@freebsd.org
Delivered-To: freebsd-current@freebsd.org
Date: Mon, 14 Jun 2004 19:56:42 +0100 (BST)
From: Richard Smith <spam_if_you_want_to@yahoo.co.uk>
To: freebsd-current@freebsd.org
X-The-Matrix: has you
Subject: unattended install of FreeBSD 5.2.1 does not umount disk properly
X-BeenThere: freebsd-current@freebsd.org
X-Mailman-Version: 2.1.1
Precedence: list
List-Id: Discussions about the use of FreeBSD-current
	<freebsd-current.freebsd.org>
List-Unsubscribe: <http://lists.freebsd.org/mailman/listinfo/freebsd-current>,
	<mailto:freebsd-current-request@freebsd.org?subject=unsubscribe>
List-Archive: <http://lists.freebsd.org/pipermail/freebsd-current>;
List-Post: <mailto:freebsd-current@freebsd.org>
List-Help: <mailto:freebsd-current-request@freebsd.org?subject=help>
List-Subscribe: <http://lists.freebsd.org/mailman/listinfo/freebsd-current>,
	<mailto:freebsd-current-request@freebsd.org?subject=subscribe>
Errors-To: owner-freebsd-current@freebsd.org
X-UIDL: [YC"!~Ek!!doh"!:+L"!
X-Bogosity: No, tests=bogofilter, spamicity=0.000000, version=0.17.5

I'm trying to do an unattended install of FreeBSD 5.2.1.  If I don't
include the 'shutdown' command at the end of the install.cfg file, the
install works fine, but I have to manually reboot the machine after the
install, which is no good for an unattended install.

If I do include 'shutdown', then it appears that the disk does not unmount
properly before the reboot.  The console displays "syncing
disks, buffers remaining".  Normally I would expect a few
numbers to be printed, followed by a reboot a second later. This what
happens if the reboot is performed manually from the sysinstall menu.

But when the reboot is performed automatically, after "syncing disks"  it
says: "WARNING - WRITE_DMA interrupt was seen but timeout fired LBA" and
then prints the same number (e.g. 161) over and over again for several
lines.  After about 5 seconds the system reboots, but the new installation
has errors on the filesystem and requires me to manually run fsck. This is
no good for an unattended installation.

Is there anyway to reboot the system from the install.cfg file and have
it unmount cleanly?

-- 
Richard

_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"


----- End forwarded message -----


Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20040614232715.GA98586>