Skip site navigation (1)Skip section navigation (2)
Date:      Sun, 28 Oct 2012 21:58:13 +0100
From:      Big Yuuta <init.py@gmail.com>
To:        Alexander Motin <mav@freebsd.org>
Cc:        freebsd-questions@freebsd.org
Subject:   Re: No sound from speaker, using Realtek ALC269 and snd_hda
Message-ID:  <CAN5iB8QMm80VWzRFMsD=_vDN0HNLCoU2tb-Bt6n5qjUOcLHDXA@mail.gmail.com>
In-Reply-To: <508D98C9.30603@FreeBSD.org>
References:  <CAN5iB8RJe=JY2zsDG40gtCwcf4uJBt0+txiSSuHqnZ1Ob6=HZg@mail.gmail.com> <508D8755.1080501@FreeBSD.org> <CAN5iB8T9RySw4h5HaM=pCA_G8n4yVa+Awdz4_YO8yr-FFk3iZg@mail.gmail.com> <508D98C9.30603@FreeBSD.org>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
On Sun, Oct 28, 2012 at 9:42 PM, Alexander Motin <mav@freebsd.org> wrote:
> On 28.10.2012 22:09, Big Yuuta wrote:
>>>
>>> CODEC configuration looks good and I see no problems in driver output. I
>>> think most likely problem is in CODEC wiring and power amplifier. Your
>>> CODEC
>>> has two GPIO lines and EAPD line. That gives 8 possible combinations. I
>>> would recommend you to try them all. GPIOs, as you tried could be set
>>> with
>>> hint.hdaa.0.gpio_config tunable. EAPD line can be controlled (0 or 100)
>>> by
>>> the ogain mixer control.
>>
>>
>> You mean combinations like:
>>
>> hint.hdaa.0.gpio_config="0=set 1=set 2=set"
>
>
> As I've told, there are only two GPIO pins, so only "0=X 1=Y", plus ogain
> mixer control.

So that would be:

hint.hdaa.0.gpio_config="0=set 1=set"
hint.hdaa.0.gpio_config="0=set 1=clear"
hint.hdaa.0.gpio_config="0=clear 1=set"
hint.hdaa.0.gpio_config="0=clear 1=clear"

which I try with:

mixer ogain 0:0
mixer ogain 100:100

I'm going to check once again, but I think that unfortunately that didn't work.
I hope that I forgot a combination!

Thanks again, Alexander



Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?CAN5iB8QMm80VWzRFMsD=_vDN0HNLCoU2tb-Bt6n5qjUOcLHDXA>