Date: Mon, 3 Jun 2019 20:50:42 +0900 (JST) From: Mori Hiroki <yamori813@yahoo.co.jp> To: Ronald Klop <ronald-lists@klop.ws>, "freebsd-arm@freebsd.org" <freebsd-arm@freebsd.org>, "freebsd-stable@freebsd.org" <freebsd-stable@freebsd.org> Subject: Re: boot 11.3-BETA1 hangs om armv5 Message-ID: <1442525240.1981975.1559562642958.JavaMail.yahoo@jws704001.mail.kks.yahoo.co.jp> In-Reply-To: <op.z2gsinvwkndu52@sjakie> References: <op.z2gsinvwkndu52@sjakie>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi. I build and flash on arm/ralink today by CURRENT. arm/ralink is hangup at same point too. Hiroki Mori ----- Original Message ----- > From: Ronald Klop <ronald-lists@klop.ws> > To: freebsd-arm@freebsd.org; "freebsd-stable@freebsd.org" <freebsd-stable= @freebsd.org> > Cc:=20 > Date: 2019/5/28, Tue 05:00 > Subject: boot 11.3-BETA1 hangs om armv5 >=20 > Was running "FreeBSD 11.2-RELEASE-p4 (SHEEVAPLUG) #4 r339336M: Sat Oct 13= =C2=A0=20 > 23:31:51 CEST 2018". > Compiled 11.3-BETA1, installed kernel.bin in /boot/msdos and started it.= =C2=A0=20 > Output below. It hangs. I guess in starting the random/entropy stuff. >=20 > Any thoughts or advise? > Don't spend to much time on it, I'm happy to phase it out. >=20 > Regards, > Ronald. >=20 >=20 > Rebooting... >=20 > =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 __=C2=A0 __=C2=A0 =C2=A0 =C2=A0 =C2=A0= =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 _ _ > =C2=A0 =C2=A0 =C2=A0 =C2=A0 |=C2=A0 \/=C2=A0 | __ _ _ ____=C2=A0 _____|= | | > =C2=A0 =C2=A0 =C2=A0 =C2=A0 | |\/| |/ _` | '__\ \ / / _ \ | | > =C2=A0 =C2=A0 =C2=A0 =C2=A0 | |=C2=A0 | | (_| | |=C2=A0 \ V /=C2=A0 __/= | | > =C2=A0 =C2=A0 =C2=A0 =C2=A0 |_|=C2=A0 |_|\__,_|_|=C2=A0 =C2=A0 \_/ \___|= _|_| > =C2=A0 _=C2=A0 _=C2=A0 =C2=A0 ____=C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 = =C2=A0 =C2=A0 _ > | | | |=C2=A0 | __ )=C2=A0 ___=C2=A0 ___ | |_ > | | | |___|=C2=A0 _ \ / _ \ / _ \| __| > | |_| |___| |_) | (_) | (_) | |_ > =C2=A0 \___/=C2=A0 =C2=A0 |____/ \___/ \___/ \__| > =C2=A0 ** MARVELL BOARD: SHEEVA PLUG LE >=20 > U-Boot 1.1.4 (Mar 19 2009 - 16:06:59) Marvell version: 3.4.16 >=20 > U-Boot code: 00600000 -> 0067FFF0=C2=A0 BSS: -> 006CEE80 >=20 > Soc: 88F6281 A0 (DDR2) > CPU running @ 1200Mhz L2 running @ 400Mhz > SysClock =3D 400Mhz , TClock =3D 200Mhz >=20 > DRAM CAS Latency =3D 5 tRP =3D 5 tRAS =3D 18 tRCD=3D6 > DRAM CS[0] base 0x00000000=C2=A0 size 256MB > DRAM CS[1] base 0x10000000=C2=A0 size 256MB > DRAM Total size 512MB=C2=A0 16bit width > Flash:=C2=A0 0 kB > Addresses 8M - 0M are saved for the U-Boot usage. > Mem malloc Initialization (8M - 7M): Done > NAND:512 MB >=20 > CPU : Marvell Feroceon (Rev 1) >=20 > Streaming disabled > Write allocate disabled >=20 >=20 > USB 0: host mode > PEX 0: interface detected no Link. > Net:=C2=A0 egiga0 [PRIME], egiga1 > Hit any key to stop autoboot:=C2=A0 0 > (Re)start USB... > USB:=C2=A0 scanning bus for devices... 4 USB Device(s) found > =C2=A0 =C2=A0 =C2=A0 =C2=A0 scanning bus for storage devices... 1 Storage= Device(s) found > reading kernel.bin > . > .........................................................................= ...........................................................................= ...........................................................................= ...........................................................................= ...........................................................................= ................................................... >=20 > 4345316 bytes read > ## Starting application at 0x00900000 ... > Copyright (c) 1992-2019 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > =C2=A0=C2=A0=C2=A0 The Regents of the University of California. All right= s reserved. > FreeBSD is a registered trademark of The FreeBSD Foundation. > FreeBSD 11.3-BETA1 #0 r348277M: Sun May 26 14:17:08 CEST 2019 > =C2=A0 =C2=A0 builder@rpi3:/data/src/obj-11.3/arm.arm/data/src/11.3/sys/S= HEEVAPLUG=C2=A0=20 > arm > FreeBSD clang version 8.0.0 (tags/RELEASE_800/final 356365) (based on LLV= M=C2=A0=20 > 8.0.0) > CPU: Feroceon 88FR131 rev 1 (**unknown 4** core) > =C2=A0 Little-endian DC enabled IC disabled WA disabled DC streaming ena= bled > =C2=A0 BTB disabled L2 enabled L2 prefetch enabled > =C2=A0 WB enabled LABT branch prediction disabled > =C2=A0 16KB/32B 4-way instruction cache > =C2=A0 16KB/32B 4-way write-back-locking-C data cache > real memory=C2=A0 =3D 536866816 (511 MB) > avail memory =3D 518778880 (494 MB) > SOC: Marvell 88F6281 rev A0, TClock 200MHz > =C2=A0 Instruction cache prefetch enabled, data cache prefetch enabled > =C2=A0 256KB 4-way set-associative write-through unified L2 cache > random: entropy device external interface > _______________________________________________ > freebsd-arm@freebsd.org mailing list > https://lists.freebsd.org/mailman/listinfo/freebsd-arm=20 > To unsubscribe, send any mail to "freebsd-arm-unsubscribe@freebsd.org" >=20
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?1442525240.1981975.1559562642958.JavaMail.yahoo>