Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 22 Nov 2002 19:33:43 -0800
From:      "Maksim Yevmenkin" <Maksim.Yevmenkin@cw.com>
To:        "M. Warner Losh" <imp@bsdimp.com>
Cc:        <vova@sw.ru>, <shizukakudo_99@yahoo.com>, <freebsd-current@FreeBSD.ORG>
Subject:   RE: Bluetooth questions
Message-ID:  <45258A4365C6B24A9832BFE224837D552B1265@sjdcex01.int.exodus.net>

next in thread | raw e-mail | index | archive | help

> In message: =
<45258A4365C6B24A9832BFE224837D552B1264@sjdcex01.int.exodus.net>
>            "Maksim Yevmenkin" <Maksim.Yevmenkin@cw.com> writes:
> : I see a lot of "silo overflow" errors under moderate load.
> : As a result bytes get dropped on the floor. The Bluetooth
> : spec defines extremely simple serial protocol (H4). It simply
> : cannot tolerate UARTs that drop bytes. If at least one byte
> : gets dropped the entire HCI frame is lost. If HCI frame gets
> : dropped then "out of sync" condition exist and all bets are
> : off. The only way to get back "in sync" is to send Reset to
> : the device. After Reset device goes into standby state and
> : all operational state is lost.=20
>=20
> OK.  That makes sense.  Part of the problem even with even fast
> interrupt handlers is that interrupts are masked for way way too much
> code in -current, as compared to -stable.  What baud rate are you
> running at?  I'm running at 56k, which isn't the full datarate for
> 115200 baud that could be used.  Even with a fast interrupt, you'd get
> SIO overflows in current, at least according to some reports.

everything is set to 115200, but i think the hardware does=20
something funny with the divisor and internal rate is much
higher. with OLDCARD i managed to run Xircom card with fast
interrupts and acually got about 50 KBytes/sec. USB devices
give me about 60KBytes/sec.

> Hmmm, maybe I should get one of these cards, or one a normal sio
> cards and run them at 115200 baud.

good idea.

thanks,
max




To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-current" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?45258A4365C6B24A9832BFE224837D552B1265>