Date: Fri, 8 Oct 1999 12:32:34 -0500 (CDT) From: Rich Winkel <rich@chumbly.math.missouri.edu> To: freebsd-questions@freebsd.org Subject: cdrecord problem Message-ID: <199910081732.MAA23402@chumbly.math.missouri.edu>
next in thread | raw e-mail | index | archive | help
I'm trying to burn the 3.3 CD image to a Plextor PX-R412CS CD-R,
which the documentation says is supported. The dummy write seemed
to go fine, but the actual write bombed saying
cdrecord: Data does not fit on current disk.
Here are the dummy and actual runs, followed by dmesg output.
Does anyone know what the problem is?
henon# cdrecord -dummy -v speed=2 dev=6,0 3.3-install.cd0
Cdrecord release 1.8a29 Copyright (C) 1995-1999 Jörg Schilling
TOC Type: 1 = CD-ROM
scsidev: '6,0'
scsibus: 0 target: 6 lun: 0
Using libscg version 'schily-0.1'
atapi: 0
Device type : Removable CD-ROM
Version : 2
Response Format: 2
Capabilities : SYNC LINKED
Vendor_info : 'PLEXTOR '
Identifikation : 'CD-R PX-R412C '
Revision : '1.04'
Device seems to be: Generic mmc CD-R.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : SWABAUDIO
Drive buf size : 1168944 = 1141 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 643 MB
Total size: 739 MB (73:14.74) = 329606 sectors
Lout start: 739 MB (73:16/56) = 329606 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 4
Is unrestricted
Is not erasable
ATIP start of lead in: -11580 (97:27/45)
ATIP start of lead out: 333226 (74:05/01)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 9
Manufacturer: Kodak Japan Limited
Blocks total: 333226 Blocks current: 333226 Blocks remaining: 3620
RBlocks total: 343358 RBlocks current: 343358 RBlocks remaining: 13752
Starting to write CD/DVD at speed 2 in dummy mode for single session.
Last chance to quit, starting dummy write in 1 seconds.
Waiting for reader process to fill input-buffer ... input-buffer ready.
Starting new track at sector: 0
Track 01: 643 of 643 MB written (fifo 100%).
Track 01: Total bytes read/written: 675028992/675028992 (329604 sectors).
Writing time: 2204.761s
Fixating...
WARNING: Some drives don't like fixation in dummy mode.
cdrecord: Input/output error. close track/session: scsi sendcmd: retryable error
CDB: 5B 00 02 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 09 00 00 00 00 0A 00 00 00 00 80 01 00 00 00 00
Sense Key: 0x9 Vendor Unique, Segment 0
Sense Code: 0x80 Qual 0x01 (vendor unique sense code 0x80) [No matching qualifier] Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.001s timeout 480s
Fixating time: 0.089s
cdrecord: fifo had 10633 puts and 10633 gets.
cdrecord: fifo was 0 times empty and 10549 times full, min fill was 96%.
henon# cdrecord -v speed=2 dev=6,0 3.3-install.cd0
Cdrecord release 1.8a29 Copyright (C) 1995-1999 Jörg Schilling
TOC Type: 1 = CD-ROM
scsidev: '6,0'
scsibus: 0 target: 6 lun: 0
Using libscg version 'schily-0.1'
atapi: 0
Device type : Removable CD-ROM
Version : 2
Response Format: 2
Capabilities : SYNC LINKED
Vendor_info : 'PLEXTOR '
Identifikation : 'CD-R PX-R412C '
Revision : '1.04'
Device seems to be: Generic mmc CD-R.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : SWABAUDIO
Drive buf size : 1168944 = 1141 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 643 MB
Total size: 739 MB (73:14.74) = 329606 sectors
Lout start: 739 MB (73:16/56) = 329606 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 4
Is unrestricted
Is not erasable
ATIP start of lead in: -11580 (97:27/45)
ATIP start of lead out: 333226 (74:05/01)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 9
Manufacturer: Kodak Japan Limited
Blocks total: 333226 Blocks current: 3470 Blocks remaining: -326136
cdrecord: WARNING: Data may not fit on current disk.
RBlocks total: 343358 RBlocks current: 13602 RBlocks remaining: -316004
cdrecord: Data does not fit on current disk.
------------------dmesg---------------
Copyright (c) 1992-1999 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 3.3-STABLE #0: Tue Oct 5 17:42:59 CDT 1999
root@crayon:/u2/src/sys/compile/g6_da1
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 199432989 Hz
CPU: Pentium Pro (199.43-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x619 Stepping = 9
Features=0xf9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV>
real memory = 67108864 (65536K bytes)
avail memory = 62611456 (61144K bytes)
Preloaded elf kernel "kernel" at 0xc0287000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc028709c.
Pentium Pro MTRR support enabled
Probing for devices on PCI bus 0:
Correcting Natoma config for non-SMP
chip0: <Intel 82440FX (Natoma) PCI and memory controller> rev 0x02 on pci0.0.0
chip1: <Intel 82371SB PCI to ISA bridge> rev 0x01 on pci0.7.0
ahc0: <Adaptec 2940 Ultra SCSI adapter> rev 0x00 int a irq 10 on pci0.11.0
ahc0: aic7880 Wide Channel A, SCSI Id=7, 16/255 SCBs
xl0: <3Com 3c905-TX Fast Etherlink XL> rev 0x00 int a irq 9 on pci0.15.0
xl0: Ethernet address: 00:60:97:90:74:f4
xl0: autoneg complete, link status good (half-duplex, 10Mbps)
vga0: <Matrox MGA 2064W graphics accelerator> rev 0x01 int a irq 11 on pci0.17.0Probing for devices on the ISA bus:
sc0 on isa
sc0: VGA color <16 virtual consoles, flags=0x0>
atkbdc0 at 0x60-0x6f on motherboard
atkbd0 irq 1 on isa
psm0 irq 12 on isa
psm0: model IntelliMouse, device ID 3
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
fd0: 1.44MB 3.5in
vga0 at 0x3b0-0x3df maddr 0xa0000 msize 131072 on isa
npx0 on motherboard
npx0: INT 16 interface
changing root device to da1s1a
da1 at ahc0 bus 0 target 1 lun 0
da1: <SEAGATE ST32155W 0362> Fixed Direct Access SCSI-2 device
da1: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled
da1: 2049MB (4197405 512 byte sectors: 255H 63S/T 261C)
da0 at ahc0 bus 0 target 0 lun 0
da0: <SEAGATE ST32155W 0362> Fixed Direct Access SCSI-2 device
da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled
da0: 2049MB (4197405 512 byte sectors: 255H 63S/T 261C)
cd0 at ahc0 bus 0 target 5 lun 0
cd0: <PLEXTOR CD-ROM PX-12TS 1.02> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 15)
cd0: Attempt to query device size failed: NOT READY, Medium not present
cd1 at ahc0 bus 0 target 6 lun 0
cd1: <PLEXTOR CD-R PX-R412C 1.04> Removable CD-ROM SCSI-2 device
cd1: 10.000MB/s transfers (10.000MHz, offset 8)
cd1: Attempt to query device size failed: NOT READY, Medium not present
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199910081732.MAA23402>