Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 11 Sep 2001 10:20:11 -0400
From:      "Russell D. Murphy Jr." <rdmurphy@vt.edu>
To:        Warner Losh <imp@harmony.village.org>
Cc:        FreeBSD-mobile@FreeBSD.ORG
Subject:   Re: pccardd and TI PCI-1250 PCI-CardBus Bridge
Message-ID:  <15262.7579.175475.703603@localhost.econ.vt.edu>
In-Reply-To: <200109110232.f8B2W6t29273@harmony.village.org>
References:  <15261.4103.952522.597428@localhost.econ.vt.edu> <200109110232.f8B2W6t29273@harmony.village.org>

next in thread | previous in thread | raw e-mail | index | archive | help


According to Warner Losh (September 10, 2001):
| In message <15261.4103.952522.597428@localhost.econ.vt.edu> "Russell D. Murphy Jr." writes:
| I'd use PCI interrupts.  IRQ 9 is already asigned to the bridge.

| : pcic0: <TI PCI-1250 PCI-CardBus Bridge> irq 9 at device 10.0 on pci0
| : pcic0: PCI Memory allocated: 0x44000000
| : pcic0: Polling mode
| : pcic0: TI12XX PCI Config Reg: [speaker enable][pwr save][FUNC pci int + CSC serial isa irq]
| : pccard0: <PC Card bus (classic)> on pcic0
| 
| : pcic1: <TI PCI-1250 PCI-CardBus Bridge> irq 9 at device 10.1 on pci0
| : pcic1: PCI Memory allocated: 0x44001000
| : pcic1: Polling mode
| : pcic1: TI12XX PCI Config Reg: [speaker enable][pwr save][FUNC pci int + CSC serial isa irq]
| : pccard1: <PC Card bus (classic)> on pcic1
| 
| I'd try it without any set.

I've reset /boot/loader.conf; it sets none of the hw.pcic sysctls.
Upon re-boot and insertion of the card (3Com 3C589 ethernet card), the
machine locks up solid with no messages displayed on the console.  It
does beep.  Ejecting the card switches the console (I had pressed
ALT-F2) and displays pnic: page fault on the system console.

I also tried hw.pcic.init_routing=1.  When this is set, nothing
happens when the card is inserted or ejected.  No beep, no
recognition, (no lockup).

| What is your laptop?

It's a Gateway Solo 5100 (vintage 1998).  I didn't copy down the BIOS
information, but can if it would help.  Are there BIOS setting I
should check?

Thanks for your help.

RDM


-- 
Russell D. Murphy
Department of Economics
Virginia Polytechnic Institute and State University
Blacksburg, Virginia  24061
(540) 231-4537

To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?15262.7579.175475.703603>