Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 15 Sep 2014 08:19:37 -0600
From:      Brett Glass <brett@lariat.net>
To:        pyunyh@gmail.com
Cc:        questions@freebsd.org, net@freebsd.org
Subject:   Re: jme interface bounces up and down, up and down....
Message-ID:  <201409151447.IAA08325@mail.lariat.net>
In-Reply-To: <20140915060819.GA967@michelle.fasterthan.com>
References:  <201409141629.KAA29705@mail.lariat.net> <20140915060819.GA967@michelle.fasterthan.com>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
At 12:08 AM 9/15/2014, Yonghyeon PYUN wrote:

>Would you show me the output of dmesg(jme(4) and jmphy(4) only) to
>know exact chip revision?

Here you are.

jme0: <JMicron Inc, JMC25x Gigabit Ethernet> port 
0xec80-0xecff,0xe800-0xe8ff mem 0xfbffc000-0xfbfff
fff irq 18 at device 0.0 on pci1
jme0: MSIX count : 8
jme0: MSI count : 8
jme0: attempting to allocate 1 MSI-X vectors (8 supported)
msi: routing MSI-X IRQ 256 to local APIC 0 vector 52
jme0: using IRQ 256 for MSI-X
jme0: Using 1 MSIX messages.
jme0: PCI device revision : 0x0250
jme0: Chip revision : 0x11
jme0: ethernet hardware address not found in EEPROM.
jme0: PHY is at address 1.
jme0: Read request size : 512 bytes.
jme0: TLP payload size : 128 bytes.
miibus0: <MII bus> on jme0
jmphy0: <JMP211 10/100/1000 media interface> PHY 1 on miibus0
jmphy0: OUI 0x00d831, model 0x0021, rev. 1
jmphy0:  none, 10baseT, 10baseT-FDX, 10baseT-FDX-flow, 100baseTX, 
100baseTX-FDX, 100baseTX-FDX-flow,
  1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, 
1000baseT-FDX-flow, 1000baseT-FDX
-flow-master, auto, auto-flow
jme0: bpf attached
jme0: Ethernet address: e0:cb:4e:54:23:ac

I do not particularly like JMicron chips (their faulty SSD 
controllers have cost me a lot of time and money), but that's 
what's on the motherboard of this Asus. So, I need to find a way to 
make it work.

--Brett Glass




Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?201409151447.IAA08325>