Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 13 Mar 2000 22:29:28 +0100
From:      Anne Marcel Roorda <marcel@eu.uu.net>
To:        Jesper Skriver <jesper@skriver.dk>
Cc:        Morten Seeberg <ml@seeberg.dk>, mobile@freebsd.org
Subject:   Re: pcm driver on Thinkpad 600E (2645) 
Message-ID:  <QQigjt11608.200003132129@anocserve1.ams.ops.eu.uu.net>
In-Reply-To: Your message of "Mon, 13 Mar 2000 22:20:23 %2B0100." <20000313222023.A52969@skriver.dk> 

next in thread | previous in thread | raw e-mail | index | archive | help

  
  --ZPt4rx8FFjLCG7dd
  Content-Type: text/plain; charset=us-ascii
  
  On Mon, Mar 13, 2000 at 10:09:11PM +0100, Anne Marcel Roorda wrote:
  >>   > 
  >>   >   Adding "options PNPBIOS" to the kernel config should get this
  >>   > working.
  >>   > 
  >>   >   From a working TP600E:
  >>   > 
  >>   > csa0: <Crystal Semiconductor CS4610/4611 Audio accelerator> mem 0x5000
  0000-
  >>   0x500fffff,0x50100000-0x50100fff irq 11 at device 6.0 on pci0
  >>   > pcm0: <CS423x-PCI> at port 0x530-0x537,0x388-0x38b,0x220-0x233 irq 5 d
  rq 1,
  >>   0 on isa0
  >>   
  >>   This got my sound working, but now ep0 (a 3c589c) doesn't work, it
  >>   complains like
  >>   
  >>   ep0: No irq?!
  >>   
  >>   It works find when I remove PNPBIOS again, any ideas ?
  >   
  > Hi,
  > 
  >   Yes, a few :)
  > 
  >   I'm assuming that you're using the PCMCIA version. If you
  > check the list of available IRQ's, then you'll probably find one
  > that's in use already listed there.
  >
  >   I'm including the pccard.conf file as I'm currently using it,
  > stripped so it only contains things that I actually use, and all 
  > cards configured to allow me to mix and match as I need them.
  
  I've tried only to include irq 10 (that is normally used) in the list,
  and listing it at the config line (config 0x1 "ep0" 10), none of these
  does the trick, and irq 10 is not used, dmesg attached ....
  
Hi,

  It would appear that IRQ 10 is already spoken for..

unknown9: <IBM3765> at port 0x130-0x13f,0x2f8-0x2ff irq 3,10 drq 7 on isa0

  As far as I can see IRQ 9 is not used by anything. Could you
give that a try?

- marcel

  
  --ZPt4rx8FFjLCG7dd
  Content-Type: text/plain
  Content-Description: dmesg.pnp.txt
  Content-Disposition: attachment; filename="dmesg.pnp.txt"
  
  Copyright (c) 1992-2000 The FreeBSD Project.
  Copyright (c) 1982, 1986, 1989, 1991, 1993
  	The Regents of the University of California. All rights reserved.
  FreeBSD 4.0-CURRENT #4: Mon Mar 13 21:22:22 CET 2000
      root@tam:/usr/src/sys/compile/TAM
  Timecounter "i8254"  frequency 1193182 Hz
  CPU: Pentium II/Pentium II Xeon/Celeron (363.96-MHz 686-class CPU)
    Origin = "GenuineIntel"  Id = 0x66a  Stepping = 10
    Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV
  ,PAT,PSE36,MMX,FXSR>
  real memory  = 66912256 (65344K bytes)
  config> q
  avail memory = 61743104 (60296K bytes)
  Preloaded elf kernel "kernel" at 0xc0303000.
  Preloaded userconfig_script "/boot/kernel.conf" at 0xc030309c.
  Pentium Pro MTRR support enabled
  md0: Malloc disk
  npx0: <math processor> on motherboard
  npx0: INT 16 interface
  apm0: <APM BIOS> on motherboard
  apm: found APM BIOS v1.2, connected at v1.2
  pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
  pci0: <PCI bus> on pcib0
  pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
  pci1: <PCI bus> on pcib1
  pci1: <NeoMagic MagicMedia 256AV SVGA controller> at 0.0 irq 11
  pcic-pci0: <TI PCI-1251 PCI-CardBus Bridge> mem 0x50102000-0x50102fff irq 11 
  at device 2.0 on pci0
  pcic-pci1: <TI PCI-1251 PCI-CardBus Bridge> mem 0x50101000-0x50101fff irq 11 
  at device 2.1 on pci0
  csa0: <Crystal Semiconductor CS4610/4611 Audio accelerator> mem 0x50000000-0x
  500fffff,0x50100000-0x50100fff irq 11 at device 6.0 on pci0
  pcm0: <CS461x PCM Audio> on csa0
  isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
  isa0: <ISA bus> on isab0
  atapci0: <Intel PIIX4 ATA33 controller> port 0xfcf0-0xfcff at device 7.1 on p
  ci0
  ata0: at 0x1f0 irq 14 on atapci0
  ata1: at 0x170 irq 15 on atapci0
  uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x8400-0x841f irq 11 at
   device 7.2 on pci0
  usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
  usb0: USB revision 1.0
  uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
  uhub0: 2 ports with 2 removable, self powered
  chip1: <Intel 82371AB Power management controller> port 0xefa0-0xefaf at devi
  ce 7.3 on pci0
  fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
  fdc0: FIFO enabled, 8 bytes threshold
  atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
  atkbd0: <AT Keyboard> irq 1 on atkbdc0
  psm0: <PS/2 Mouse> irq 12 on atkbdc0
  psm0: model Generic PS/2 mouse, device ID 0
  vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
  sc0: <System console> on isa0
  sc0: VGA <16 virtual consoles, flags=0x200>
  pcic: polling mode
  pcic: polling mode
  pcic0: <Intel i82365> on isa0
  pccard0: <PC Card bus -- kludge version> on pcic0
  pccard1: <PC Card bus -- kludge version> on pcic0
  sio0: configured irq 4 not in bitmap of probed irqs 0
  sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
  sio0: type 8250
  unknown: <PNP0000> can't assign resources
  unknown0: <PNP0200> at port 0-0xf,0x80-0x8f,0xc0-0xdf drq 4 on isa0
  unknown1: <PNP0100> at port 0x40-0x43 irq 0 on isa0
  unknown2: <PNP0b00> at port 0x70-0x73 irq 8 on isa0
  unknown: <PNP0800> can't assign resources
  unknown: <PNP0303> can't assign resources
  unknown: <IBM3780> can't assign resources
  unknown3: <PNP0c04> at port 0xf0-0xff irq 13 on isa0
  unknown: <PNP0700> can't assign resources
  unknown4: <PNP0a03> at port 0xcf8-0xcff on isa0
  unknown5: <PNP0c02> at port 0x22,0x2e-0x2f,0x92,0xb2-0xb3,0x4d0-0x4d1,0x15e0-
  0x15ef,0xef00-0xefaf iomem 0-0x9ffff,0xf0000-0xfffff,0x100000-0x3ffffff,0xfff
  f0000-0xffffffff on isa0
  unknown6: <PNP0400> at port 0x3bc-0x3bf irq 7 on isa0
  unknown: <PNP0501> can't assign resources
  pcm1: <CS423x-PCI> at port 0x530-0x537,0x388-0x38b,0x220-0x233 irq 5 drq 1,0 
  on isa0
  unknown7: <CSC0110> at port 0x538-0x53f on isa0
  unknown8: <CSC0101> at port 0x200-0x207 on isa0
  unknown: <CSC0103> can't assign resources
  unknown9: <IBM3765> at port 0x130-0x13f,0x2f8-0x2ff irq 3,10 drq 7 on isa0
  unknown: <IBM0071> can't assign resources
  unknown10: <PNP0e03> at port 0x3e0-0x3e1 on isa0
  unknown: <PNP0680> can't assign resources
  unknown: <PNP0680> can't assign resources
  unknown11: <PNP0c02> on isa0
  IP packet filtering initialized, divert enabled, rule-based forwarding disabl
  ed, default to deny, logging limited to 100 packets/entry by default
  DUMMYNET initialized (000106)
  ad0: 6149MB <HITACHI_DK239A-65B> [13328/15/63] at ata0-master using UDMA33
  acd0: CDROM <TOSHIBA CD-ROM XM-1902B> at ata1-master using PIO4
  Mounting root from ufs:/dev/ad0s2a
  pccard: card inserted, slot 1
  cmd ntpd pid 95 tried to use non-present sched_get_priority_max
  cmd ntpd pid 95 tried to use non-present sched_setscheduler
  ep0: No irq?!
  
  --ZPt4rx8FFjLCG7dd--
  

- marcel


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?QQigjt11608.200003132129>