Date: Thu, 08 Feb 1996 03:40:11 -0800 From: Chris Yeager <cyeager@calweb.com> To: bugs@freebsd.org Subject: Help with Partitions ... Crazy soon. Message-ID: <3119E11B.41C67EA6@calweb.com>
next in thread | raw e-mail | index | archive | help
Jordan or whom reads this:
Quest: 1 Bsd partition, 1 swap, and 1 Msdos partition.
I have attempted to partition it with fdisk {BSD} as well as pfdisk. Not too sure
what is the correct sequence. I have tried disklabel with and without fdisk
partitioning. Please let me know what I should do in sequence. Any help
appreciated! I have spent three whole nights with this... I hope I am not over
killing..
I wrote this disktab entry which gives the error -
partition c: partition extends past end of unit
partition e: partition extends past end of unit
ST11200N| Seagate Sun1 1.05 SCSI:\
:dt=SCSI:ty=winchester:se#512:ns#73:nt#15:nc#1872:rm#4400: \
:pa#907143:oa#0:ta=4.2BSD:ba#8192:fa#1024: \
:pb#127996:ob#907143:ta=swap: \
:pc#2059140:oc#0: \
:pe#1023968:oe#1035139:ta=4.2BSD:ba#8192:fa#1024:
These are close specifications of the disk:
Specifications
ST11200N
Hawk 1
UNFORMATTED CAPACITY (MB) ________________1,248
FORMATTED CAPACITY (xx SECTORS) (MB) _____1,054
AVERAGE SECTORS PER TRACK ________________73
ACTUATOR TYPE ____________________________VOICE COIL
TRACKS ___________________________________28,080
CYLINDERS ________________________________1,872 (user)
HEADS ____________________________________15
DISCS (3.5 in) ___________________________8
MEDIA TYPE _______________________________THIN FILM
RECORDING METHOD _________________________ZBR RLL (1,7)
INTERNAL TRANSFER RATE (mbits/sec) _______23.2 to 40.6
EXTERNAL TRANSFER RATE (mbyte/sec) _______4 Async
EXTERNAL TRANSFER RATE (mbyte/sec) _______10 Sync
SPINDLE SPEED (RPM) ______________________5,411
AVERAGE LATENCY (mSEC) ___________________5.4
BUFFER ___________________________________256 Kbyte
Read Look-Ahead, Adaptive,
Multi-Segmented Cache
INTERFACE ________________________________SCSI-2 Fast
BYTES PER TRACK __________________________41,660 avg.
SECTORS PER DRIVE ________________________2,059,139
TPI (TRACKS PER INCH) ____________________2,150
AVERAGE ACCESS (ms) (read/write)__________10.5/11.2
Drive level without controller overhead
SINGLE TRACK SEEK (ms) ___________________1.5/2.0
MAX FULL SEEK (ms) _______________________20.0/21.0
MTBF (power-on hours) ____________________200,000
POWER REQUIREMENTS: +12V START-UP (amps) _2.0
+12V TYPICAL (amps) __0.5
+5V TYPICAL (amps) ___0.4
TYPICAL (watts) ______11
IDLE (watts) _________9
LANDING ZONE (cyl)________________________AUTO PARK
IBM AT DRIVE TYPE ________________________0 or NONE
Already low-level formatted at the factory.
ZBR = Zone Bit Recording = Variable sectors per track
Formatted at the factory with 12 spare sectors per cylinder
and two spare cylinders at inner tracks per unit.
Thanks !!
<Chris Yeager> cyeager@calweb.com
--
--
Æ
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3119E11B.41C67EA6>