Date: Mon, 8 Nov 2004 15:30:59 +0100 From: =?iso-8859-2?Q?=A3ukasz?= Dudek <mocart@pinco.pl> To: freebsd-pf@freebsd.org Subject: pf multipath nat Message-ID: <20041108143059.GA54873@dorbja.pinco.pl>
next in thread | raw e-mail | index | archive | help
Hello,
i've tried to configure multipath nat using RELENG_5 box
(when it was current and now when it became stable)
this are simplified rules schema i've been using
nat on $ext_if1 from $int_subnet to any -> ($ext_if1)
nat on $ext_if2 from $int_subnet to any -> ($ext_if2)
#
## routing for internal subnets
pass in on $int_if \
route-to { ( $ext_if1 $gateway1), ( $ext_if2 $gateway2 ) } round-robin \
from $int_subnet to any keep state
## need the next rules to properly pass traffic to/from the external IPs
pass out on $ext_if2 route-to ($ext_if1 $gateway1) from $ext_if1 to any
pass out on $ext_if1 route-to ($ext_if2 $gateway2) from $ext_if2 to any
every time i've loaded this rules machine hangs hard in 30 to 300
seconds leaving nothing on special information on console or in logs
i've been manipulating debug.mpsafenet without any change
i've compiled in remote console via serial cable support
i've also compiled in required debugging options.
and it shows nothing but i've been able to send break.
and probably manualy send doadump (i didnt try)
then i've setup an openbsd 3.5 generic install on another disk
and just copied my pf.conf to started the machine and everything
was working fine for few hours.
so i'm curios what should i look for to make it working on freebsd, or
meaby something is wrong whith my configuration or freebsd.
Regards,
Lukasz Dudek
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20041108143059.GA54873>