Date: Sat, 18 Jul 1998 01:16:47 -0500 From: Paul Saab <paul@mu.org> To: Eric Hake <eric@clean.net>, questions@FreeBSD.ORG Subject: Re: Intel EtherExpress PCI 100 Message-ID: <19980718011647.A26767@mu.org> In-Reply-To: <3.0.5.32.19980717230344.007b93b0@clean.net>; from Eric Hake on Fri, Jul 17, 1998 at 11:03:44PM -0700 References: <3.0.5.32.19980717213549.007b7430@clean.net> <3.0.5.32.19980717184910.007c56f0@clean.net> <002101bdb1f1$6d5eb580$0100a8c0@asus.hyperhost.net> <3.0.5.32.19980717213549.007b7430@clean.net> <19980717235613.A26321@mu.org> <3.0.5.32.19980717230344.007b93b0@clean.net>
next in thread | previous in thread | raw e-mail | index | archive | help
It isn't supported.. It uses the 82556 ethernet chip and the fxp driver looks for the 82557. Paul Eric Hake (eric@clean.net) wrote: > I did some research, and tracked this board down as being the following: > > PILA8465 - Intel PRO/100 Smart Adapter > (see: http://www.intel.com/network/doc/1868/INDEX.HTM#specs2 ) > > Does this make it incompatible? (kinda an obvious question)... > > Is there any way to get it to work under FBSD? > > If not, does anybody have any used, or cheap Pro/100B's hanging around??? > > Thanks! > Eric > > > > > At 11:56 PM 7/17/98 -0500, you wrote: > >It would be under PCI, and it is there on the GENERIC kernel. What > >the chip on the card? Could you have gotten the new Intel EtherExpress > >Pro/100 with remote wakeup? I don't know if this borad will work > >with the current driver or not. > > > >Paul > > > >Eric Hake (eric@clean.net) wrote: > >> At 10:11 PM 7/17/98 -0400, you wrote: > >> >I b'lieve that means it isn't supported by FBSD (yet). > >> >My Buslogic Flashpoint LT SCSI card says that too. > >> > >> The Walnut Creek CD Case says "Intel EtherExpress Pro/100" under the > >> networking hardware support -- but in the setup, it only lists the > >> EtherExpress Pro/10... Is there some other way to get to the Pro/100 during > >> boot?? > >> > >> Thanks! > >> Eric > >> > >> > >> > >> > >> To Unsubscribe: send mail to majordomo@FreeBSD.org > >> with "unsubscribe freebsd-questions" in the body of the message > > > > To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?19980718011647.A26767>