Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 2 Jan 2004 18:44:12 +0100
From:      Stefan =?iso-8859-1?Q?E=DFer?= <Stefan.Esser@SE-IT-Security.de>
To:        Daniel Ortiz <d.ortiz@in.ilimit.es>
Cc:        freebsd-hardware@freebsd.org
Subject:   Re: atacontrol/udma
Message-ID:  <20040102174412.GA11623@StefanEsser.FreeBSD.org>
In-Reply-To: <20040102172838.GB211@in.ilimit.es>
References:  <20040102114156.GB7190@in.ilimit.es> <20040102171730.GB11022@StefanEsser.FreeBSD.org> <20040102172838.GB211@in.ilimit.es>

next in thread | previous in thread | raw e-mail | index | archive | help
On 2004-01-02 18:28 +0100, Daniel Ortiz <d.ortiz@in.ilimit.es> wrote:
> On Fri, Jan 02, 2004 at 06:17:30PM +0100, Stefan E=DFer wrote:
> > You need to use an 80 wire cable for higher transfer speeds=20
> > than UDMA33. (Your cable appears to be of the 40 wire kind).
>=20
> A serial ata cable doesn't work?

Sorry, seems I didn't read the relevant lines of your message.

Serial ATA works on my mainboard (with a Promise PDC20376 chip).
The probe message talks about UDMA100 instead of SATA150:

atapci0: <Promise PDC20376 SATA150 controller> port 0xa800-0xa87f,0xb000-=
0xb00f,0xb400-0xb43f mem 0xcd800000-0xcd81ffff,0xce000000-0xce000fff irq =
17 at device 8.0 on pci0
ad4: 157066MB <HDS722516VLSA80> [319120/16/63] at ata2-master UDMA100

Can't tell what's wrong in your case.

Regards, STefan



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20040102174412.GA11623>