Date: Fri, 20 Jul 2001 00:25:44 -0500 From: Doug Poland <doug@polands.org> To: Doug Reynolds <mav@wastegate.net> Cc: "freebsd-questions@freebsd.org" <freebsd-questions@freebsd.org> Subject: Re: Adaptec 1522 Scuzzi Message-ID: <20010720002544.B8424@polands.org> In-Reply-To: <20010720031252.9D35937B409@hub.freebsd.org> References: <20010720031252.9D35937B409@hub.freebsd.org>
next in thread | previous in thread | raw e-mail | index | archive | help
Please wrap your lines at 80 characters please On Thu, Jul 19, 2001 at 11:09:23PM -0400, Doug Reynolds wrote: > > 2.7G Seagate ST43400N / adaptec 1522 scsi controller > Yesterday I installed an AHA 1522A/ST5660N drive/16X SCSI CD-ROM and everything worked fine. > it is @ port 0x340,irq11(have dm0,irq11 assign to legasy/isa in bios), > Are there any other ISA cards in the system that might conflict with these settings? > it detects fine when it is probed, and it detect the hard drive too. > Does it report back the settings you mentioned above? > the card & the drive as both terminated on either end (the drive > side is terminated with a 50 active, and i have terminator power > jumpered "on" on the hd itself). > I'm not sure about using passive terminators on the drive, then configuring it to see powered termination. Someone with more expertise will have to chime in here. > the problem is when i try to partition the drive, it wont bring up > da0 (or any drives for that matter) > Are you getting any error messages? > the only other thing i can think of is that i tried to Dangerously > Dedidate it as a 2nd drive b4, which means no partition table, > but i was under the impression that fbsd accessed everything as > low level as possible... > My guess is an interrupt conflict. If not, your termination is suspicious. HTH, -- Regards, Doug To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010720002544.B8424>