Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 4 Dec 2015 08:26:51 -0600
From:      Adam Vande More <amvandemore@gmail.com>
To:        mexas@bris.ac.uk
Cc:        FreeBSD Questions <freebsd-questions@freebsd.org>
Subject:   Re: help number disks via /boot/device.hints
Message-ID:  <CA+tpaK1aHV1nG3TRN_cP9jtYXupCM47X789WuyNce079Wpx_jw@mail.gmail.com>
In-Reply-To: <201512041047.tB4AlLEq091375@mech-as222.men.bris.ac.uk>
References:  <201512041047.tB4AlLEq091375@mech-as222.men.bris.ac.uk>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
On Fri, Dec 4, 2015 at 4:47 AM, Anton Shterenlikht <mexas@bris.ac.uk> wrote:

> I've a problem - when the fibre disks are connected
> at boot, the boot disk is not given da0 and I cannot boot.
> So what I do now is disconnect the fiber disk until boot
> is completed, and connect is manually afterwards.
>
> Then I get:
>
> da0 at mpt0 bus 0 scbus3 target 2 lun 0
> da0: <IBM-ESXS MAY2073RC T107> Fixed Direct Access SPC-3 SCSI device
> da0: Serial Number B399P790FBEG
> da0: 300.000MB/s transfers
> da0: Command Queueing enabled
> da0: 70006MB (143374000 512 byte sectors: 255H 63S/T 8924C)
>
> da1 at isp0 bus 0 scbus2 target 0 lun 5
> da1: <COMPAQ MSA1000 VOLUME 4.32> Fixed Direct Access SPC-2 SCSI device
> da1: Serial Number P56350GX3RX04Z
> da1: 200.000MB/s transfers WWNN 0x500805f3000ec220 WWPN 0x500805f3000ec221
> PortID 0x10000
> da1: Command Queueing enabled
> da1: 140011MB (286744185 512 byte sectors: 255H 63S/T 17849C)
>
> How can I set in /boot/device.hints that the MSA1000
> disk is da1 and IBM is the boot disk da0?
>

man 4 cam


-- 
Adam



Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?CA+tpaK1aHV1nG3TRN_cP9jtYXupCM47X789WuyNce079Wpx_jw>