From owner-freebsd-mobile Thu Aug 24 16:56:20 2000 Delivered-To: freebsd-mobile@freebsd.org Received: from po4.wam.umd.edu (po4.wam.umd.edu [128.8.10.166]) by hub.freebsd.org (Postfix) with ESMTP id 7916037B42C for ; Thu, 24 Aug 2000 16:56:18 -0700 (PDT) Received: from rac2.wam.umd.edu (rac2.wam.umd.edu [128.8.10.142]) by po4.wam.umd.edu (8.9.3/8.9.3) with ESMTP id TAA02224 for ; Thu, 24 Aug 2000 19:56:17 -0400 (EDT) Received: from rac2.wam.umd.edu (localhost [127.0.0.1]) by rac2.wam.umd.edu (8.9.3/8.9.3) with SMTP id TAA24135 for ; Thu, 24 Aug 2000 19:56:17 -0400 (EDT) Received: from localhost (culverk@localhost) by rac2.wam.umd.edu (8.9.3/8.9.3) with ESMTP id TAA24131 for ; Thu, 24 Aug 2000 19:56:17 -0400 (EDT) X-Authentication-Warning: rac2.wam.umd.edu: culverk owned process doing -bs Date: Thu, 24 Aug 2000 19:56:17 -0400 (EDT) From: Kenneth Wayne Culver To: freebsd-mobile@freebsd.org Subject: Re: fe575 (again) In-Reply-To: Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-freebsd-mobile@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.org > does anything new need to go in pccard.conf to allow the fe575 to > work? It should be detected with the xl driver should it not? Ok so far this is what I've done for installing the card. I made floppies (using the make floppies target in /usr/src/release) and got floppies to build. I included the following in the pccard.conf file: card "3Com" "3Com 3c575-TX Cardbus Fast Ethernet XL" config 0x1 "xl" ? 0x1 insert /etc/pccard_ether $device remove /sbin/ifconfig $device delete I don't know if I need this, but I put it there anyway, and it went into the mfsroot.flp image, I checked it after it was built. When the machine boots the kern.flp disk, I do the visual userconfig as usual, and then when it's done, the first thing sysinstall says is the pccard stuff.. If I select yes to use pccards, it asks for a mem address... I choose the default (because it's the correct one) and the default for the next selection, and the card doesn't get configured. However, if I select yes to configure pccards, but then cancel the memory selection and irq selection, it beeps as if the card was configured, but then the screen just stays a blank blue, and if I alt-f2, the machine says signal 11 caught: this is bad... or something like that. I managed to catch the dmesg, and it says the "cardbus kludge" is in this kernel, so I'm stuck... did I put the wrong thing in pccard.conf? Ken To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-mobile" in the body of the message