Date: Sat, 31 Jan 2004 17:17:49 +0100 (CET) From: rmkml <rmkml@wanadoo.fr> To: hackers@FreeBSD.ORG Subject: Re: Promise raid ATA Timeout (fbsd49) with 250Go ! Message-ID: <Pine.LNX.4.58.0401311644060.31695@hp> In-Reply-To: <Pine.LNX.4.58.0401302326380.25813@hp> References: <Pine.LNX.4.58.0401302326380.25813@hp>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi again, I installed fbsd 49 on other disk/ide ctrl (ad0), and boot verbose : ... BIOS Geometries: 0:03fefe3f 0..1022=1023 cylinders, 0..254=255 heads, 1..63=63 sectors 0:03fffe3f 0..1022=1024 cylinders, 0..254=255 heads, 1..63=63 sectors 0 accounted for Device configuration finished. ... ad0: success setting UDMA5 on intel chip Creating DISK ad0 ar: FreeBSD check1 failed ad0: <Maxtor 6E040L0/NAR61590> ATA-7 disk at ata0-master ad0: 39205MB (80293248 sectors), 79656 C, 16 H, 63 S, 512 B ad0: 16 secs/int, 1 depth queue, UDMA100 ad0: piomode=4 dmamode=2 udmamode=6 cblid=1 ad4: success setting UDMA5 on Promise chip Creating DISK ad4 ad4: READ command timeout tag=0 serv=0 - resetting ata2: resetting devices .. ata2: mask=03 ostat0=58 ostat2=08 ad4: ATAPI 00 00 ata2-slave: ATAPI 00 00 ata2: mask=03 stat0=50 stat1=00 ad4: ATA 01 a5 ata2-slave: ATA 01 a5 ata2: devices=03 ata2-slave: ATA identify retries exceeded ad4: success setting UDMA5 on Promise chip done ar: Promise read conf failed ad4: <WDC WD2500JB-32FUA0/15.05R15> ATA-6 disk at ata2-master ad4: 238475MB (488397168 sectors), 484521 C, 16 H, 63 S, 512 B ad4: 16 secs/int, 1 depth queue, UDMA100 ad4: piomode=4 dmamode=2 udmamode=5 cblid=1 ad4: READ command timeout tag=0 serv=0 - resetting ata2: resetting devices .. ata2: mask=03 ostat0=58 ostat2=08 ad4: ATAPI 00 00 ata2-slave: ATAPI 00 00 ata2: mask=03 stat0=50 stat1=00 ad4: ATA 01 a5 ata2-slave: ATA 01 a5 ata2: devices=03 ata2-slave: ATA identify retries exceeded ad4: success setting UDMA5 on Promise chip done ad4: READ command timeout tag=0 serv=0 - resetting ata2: resetting devices .. ata2: mask=03 ostat0=58 ostat2=08 ad4: ATAPI 00 00 ata2-slave: ATAPI 00 00 ata2: mask=03 stat0=50 stat1=00 ad4: ATA 01 a5 ata2-slave: ATA 01 a5 ata2: devices=03 ata2-slave: ATA identify retries exceeded ad4: success setting UDMA5 on Promise chip done ad4: READ command timeout tag=0 serv=0 - resetting ad4: success setting PIO4 on Promise chip ad4: trying fallback to PIO mode ata2: resetting devices .. ata2: mask=03 ostat0=50 ostat2=00 ad4: ATAPI 00 00 ata2-slave: ATAPI 00 00 ata2: mask=03 stat0=50 stat1=00 ad4: ATA 01 a5 ata2: devices=01 ad4: success setting PIO4 on Promise chip done Fatal trap 12: page fault while in kernel mode fault virtual address = 0x78007a fault code = supervisor read, page not present instruction pointer = 0x8:0xc02577be stack pointer = 0x10:0xc042a27c frame pointer = 0x10:0xc042a284 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = idle interrupt mask = bio trap number = 12 panic: page fault I repeat, same hardware (promise Fasttrack100) [same two ide cable) with two ide disk Maxtor 40Go-ata133 is GOOD ! (fbsd49 installed and kernel recompiled whitout pb) Regard On Fri, 30 Jan 2004, rmkml wrote: > Date: Fri, 30 Jan 2004 23:32:23 +0100 (CET) > From: rmkml <rmkml@wanadoo.fr> > To: hackers@FreeBSD.ORG > Subject: Promise raid ATA Timeout (fbsd49) with 250Go ! > > Hi, > > I have Timeout during boot > > before panic ! > > I used fbsd v4.9release, (2x250Go WD ATA100) > > but if use v5.2R : OK no pb ! > > If I use 40Go on same Hardware : OK with 49 > > Possible Help me ? > > Where is download last 4.9 boot floppy ? > > Possible to increase the duration of initialization at the time of the > boot ? > > Regards > > Rmkml@Wanadoo.fr > > _______________________________________________ > freebsd-hackers@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-hackers > To unsubscribe, send any mail to "freebsd-hackers-unsubscribe@freebsd.org" >
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.LNX.4.58.0401311644060.31695>