Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 9 Feb 2000 18:26:23 -0800
From:      Gunnar H Reichert-Weygold <gunnar@paganlibrary.com>
To:        freebsd-questions@FreeBSD.ORG
Subject:   Re: Sound Card - I give up!
Message-ID:  <00020918274902.00340@gunnar.my.domain>
In-Reply-To: <00020819323300.00329@gunnar.my.domain>
References:  <00020819323300.00329@gunnar.my.domain>

next in thread | previous in thread | raw e-mail | index | archive | help
To all those who answered: THANK YOU!!!

I set Pnp to OFF and it recognized immediately. Yes, I set the kernl to device
pcm0 and left off the rest of the line.

KDE sounds wonderful!

Gunnar



On Tue, 08 Feb 2000, Gunnar H Reichert-Weygold wrote:
> I have a PCI PnP Awe64.
> The kernel inlcudes:
> 
> controller	pnp0			# PnP support for ISA
> device pcm0 at isa? port ? tty irq 10 drq 1 flags 0x0
> 
> The ouput from dmesg follows:
> 
> Copyright (c) 1992-1999 FreeBSD Inc.
> Copyright (c) 1982, 1986, 1989, 1991, 1993
> 	The Regents of the University of California. All rights reserved.
> FreeBSD 3.4-RELEASE #0: Thu Feb  3 08:16:35 PST 2000
>     root@gunnar.my.domain:/usr/src/sys/compile/FREEBIE
> Timecounter "i8254"  frequency 1193182 Hz
> CPU: Pentium II/Xeon/Celeron (334.09-MHz 686-class CPU)
>   Origin = "GenuineIntel"  Id = 0x651  Stepping = 1
>   Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR>
> real memory  = 67108864 (65536K bytes)
> avail memory = 61808640 (60360K bytes)
> Preloaded elf kernel "kernel" at 0xc0349000.
> Pentium Pro MTRR support enabled
> Probing for devices on PCI bus 0:
> chip0: <Intel 82443BX host to PCI bridge> rev 0x02 on pci0.0.0
> chip1: <Intel 82443BX host to AGP bridge> rev 0x02 on pci0.1.0
> chip2: <Intel 82371AB PCI to ISA bridge> rev 0x02 on pci0.7.0
> ide_pci0: <Intel PIIX4 Bus-master IDE controller> rev 0x01 on pci0.7.1
> uhci0: <Intel 82371AB/EB USB Host Controller> rev 0x01 int d irq 11 on pci0.7.2
> chip3: <Intel 82371AB Power management controller> rev 0x02 on pci0.7.3
> ncr0: <ncr 53c815 fast10 scsi> rev 0x04 int a irq 10 on pci0.15.0
> Probing for devices on PCI bus 1:
> vga0: <ATI model 4c42 graphics accelerator> rev 0xdc int a irq 255 on pci1.0.0
> Probing for PnP devices:
> CSN 1 Vendor ID: CTL009d [0x9d008c0e] Serial 0x00029c18 Comp ID: PNPb02f [0x2fb0d041]
> This is a SB16 PnP, but LDN 0 is disabled
> Probing for devices on the ISA bus:
> sc0 on isa
> sc0: VGA color <16 virtual consoles, flags=0x0>
> ed0 not found at 0x280
> fe0 not found at 0x300
> atkbdc0 at 0x60-0x6f on motherboard
> atkbd0 irq 1 on isa
> psm0 irq 12 on isa
> psm0: model ThinkingMouse, device ID 0
> sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa
> sio0: type 16550A
> sio1 at 0x2f8-0x2ff irq 3 on isa
> sio1: type 16550A
> pcm0 not found
> fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
> fdc0: FIFO enabled, 8 bytes threshold
> fd0: 1.44MB 3.5in
> wdc0 at 0x1f0-0x1f7 irq 14 on isa
> wdc0: unit 0 (wd0): <ST34321A>
> wd0: 4103MB (8404830 sectors), 8894 cyls, 15 heads, 63 S/T, 512 B/S
> wdc0: unit 1 (wd1): <ST313032A>
> wd1: 12419MB (25434228 sectors), 25232 cyls, 16 heads, 63 S/T, 512 B/S
> wdc1 at 0x170-0x177 irq 15 on isa
> wdc1: unit 0 (atapi): <CD-ROM 48X/AKU/U23>, removable, intr, dma, iordis
> acd0: drive speed 0 - 8250KB/sec, 128KB cache
> acd0: supported read types: CD-DA
> acd0: Audio: play, 255 volume levels
> acd0: Mechanism: ejectable tray
> acd0: Medium: CD-ROM 120mm data disc loaded, unlocked
> wdc1: unit 1 (atapi): <CRW6206A/1.2A>, removable, dma, iordy
> acd1: drive speed 1034KB/sec, 384KB cache
> acd1: supported read types: CD-R, CD-RW, CD-DA, packet track
> acd1: supported write types: CD-R, CD-RW, test write
> acd1: Audio: play, 128 volume levels
> acd1: Mechanism: ejectable tray
> acd1: Medium: CD-RW blank medium, unlocked, lock protected
> ppc0 at 0x378 irq 7 flags 0x40 on isa
> ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
> ppb0: IEEE1284 device found /NIBBLE
> Probing for PnP devices on ppbus0:
> ppbus0: <Hewlett-Packard HP LaserJet 6L/0101.01> PRINTER HP ENHANCED PCL5,PJL
> lpt0: <generic printer> on ppbus 0
> lpt0: Interrupt-driven port
> ppi0: <generic parallel i/o> on ppbus 0
> plip0: <PLIP network interface> on ppbus 0
> ie0: unknown board_id: f000
> ie0 not found at 0x300
> ep0 not found at 0x300
> ex0 not found
> le0 not found at 0x300
> lnc0 not found at 0x280
> cs0 not found at 0x300
> ze0 not found at 0x300
> zp0 not found at 0x300
> vga0 at 0x3b0-0x3df maddr 0xa0000 msize 131072 on isa
> npx0 on motherboard
> npx0: INT 16 interface
> joy0 at 0x201 on isa
> joy0: joystick
> usb0: <Intel 82371AB/EB USB Host Controller>
> uhub0 at usb0
> uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
> uhub0: 2 ports with 2 removable, self powered
> ugen0
> ugen0: Vision VC6452V002 Camera, rev 1.00/1.00, addr 2
> ugen1
> ugen1: Color FlatbedScanner 5, rev 1.00/1.21, addr 3
> Waiting 15 seconds for SCSI devices to settle
> sa0 at ncr0 bus 0 target 4 lun 0
> sa0: <CONNER CTT8000-S 1.22> Removable Sequential Access SCSI-2 device 
> sa0: 6.944MB/s transfers (6.944MHz, offset 8)
> changing root device to wd1s1a
> 
> 
> Since I've grayed too much hair on this one, what are your
> personal recommendations for a new sound card that you know works?
> 
> 
> -- 
> I used to be self-actualized, now I'm just confused.
> 
> Gunnar H Reichert-Weygold
> The Pagan Library
> http://www.paganlibrary.com
> 
> 
> To Unsubscribe: send mail to majordomo@FreeBSD.org
> with "unsubscribe freebsd-questions" in the body of the message
-- 
I used to be self-actualized, now I'm just confused.

Gunnar H Reichert-Weygold
The Pagan Library
http://www.paganlibrary.com


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?00020918274902.00340>