Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 11 Feb 2000 15:09:02 -0600 (CST)
From:      David Hansen <dhansen@salug.org>
To:        Berkeley Hamilton Ulysses <rowlands_mark@hotmail.com>
Cc:        freebsd-questions <freebsd-questions@FreeBSD.ORG>
Subject:   RE: freebsd 3.4 and pcmcia support
Message-ID:  <Pine.LNX.4.02.10002111448430.10961-100000@spaceghost.salug.org>
In-Reply-To: <200002112201.OAA22281@www.geocrawler.com>

next in thread | previous in thread | raw e-mail | index | archive | help


On Fri, 11 Feb 2000, Berkeley Hamilton Ulysses wrote:
> it is not as bad as it seems :-)

always good to hear. :)

> but try this first
> get hold of the ethernet disks from 3com - there
> is an install.exe on disk 2 (i think)
> 
> 1  boot to  a dos prompt run the install and
> configure the card to something that is actually
> available - usually irq 11 0x300

 i've already done this and it is irq 10 0x300

> 
> 2 enable pccard support for ep0   you can use
> /stand/sysinstall
> 3  using /usr/src/sys/conf/i386/PCCARD as a model 
> (make a a backup)
> 

 i did not try to configure it as ep0 since the docs that i ran across
said that zp0 replaced ep0.

> 4  using /usr/src/sys/conf/i386/PCCARD as a model 
> make sure that

 at one point i did this, but then started using GENERIC and modifying it
with information from PCCARD.

> works tolerably well for me

 well, i've tried everything else, i suppose i'll try this as well. does
this imply that zp0 is not to be used for this card after all?
(and i still have a damn 3com megahertz modem card to try to install on
this beast)

david





To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.LNX.4.02.10002111448430.10961-100000>