Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 7 Jul 2009 10:37:21 -0500
From:      Jay Hall <>
Subject:   Adaptec 29320ALP-R and tape drive
Message-ID:  <>

Next in thread | Raw E-Mail | Index | Archive | Help
I just installed an Adaptec 29320ALP-R in my FreeBSD 7.2 server.   
Connected to the card is an HP Ultrium 1/8 G2 tape drive.

During the boot sequence, FreeBSD pauses to wait for the SCSI devices  
to settle.  Then, I receive the following message

(probe79:ahd0:0:4:0: Probable outgoing LQ CRC error.  Retrying command.

I have moved the card to a different slot with the same results,  
replaced the cable, etc.   If I do not power on the tape drive, the  
system will boot normally.

Any suggestions would be greatly appreciated.



Want to link to this message? Use this URL: <>