From owner-freebsd-current Wed Jul 1 10:25:36 1998 Return-Path: Received: (from majordom@localhost) by hub.freebsd.org (8.8.8/8.8.8) id KAA17440 for freebsd-current-outgoing; Wed, 1 Jul 1998 10:25:36 -0700 (PDT) (envelope-from owner-freebsd-current@FreeBSD.ORG) Received: from base486.home.org (imdave@imdave.pr.mcs.net [205.164.3.77]) by hub.freebsd.org (8.8.8/8.8.8) with ESMTP id KAA17422 for ; Wed, 1 Jul 1998 10:25:29 -0700 (PDT) (envelope-from imdave@mcs.net) Received: (from imdave@localhost) by base486.home.org (8.8.8/8.8.8) id MAA07680; Wed, 1 Jul 1998 12:25:26 -0500 (CDT) Date: Wed, 1 Jul 1998 12:25:26 -0500 (CDT) From: Dave Bodenstab Message-Id: <199807011725.MAA07680@base486.home.org> To: current@FreeBSD.ORG, ejh@mnw.eas.slu.edu Subject: Re: Disk drive errors Toshiba 6200M Sender: owner-freebsd-current@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.ORG > From: Eric Haug > > I bought two 6200M's and both mother boards exhibit similiar problems. > I have configured two 6200M's into one with 64M memory and one processor. > Two disks by MICROPOLIS of model 4345WS > FreeBSD current FreeBSD 3.0-980520-SNAP would not successfully > newfs the f partition. I think the system just hung. > The SNAP with the CAM changes would successfully complete. > The current problem is that both disks will come up with errors > and go "offline". > With the CAM SNAP part of the error messages: > Jun 9 14:32:27 gumbo /kernel: (da1:ahc0:0:1:0): WRITE(10). CDB: 2a 0 0 79 81 f5 I have successfully built a single dual system from two 6200m's now running the 980520 snap... Your symptoms are very similar to mine. I (and other folks) had to upgrade the firmware on the Micropolis drives. The firmware upgrade is on: http://www.addit.de/SUPPORT/micr-eproms.htm It lists X504_4.exe as the current fw for the 4345xx drives (but the comment still says X502 and the link is still to ``X502_4.exe''.) Probably the ``X504'' is a typo. I still have X502_4.exe, so if you can't get it from the above site, you can get it from: ftp://ftp.mcs.net/mcsnet.users/imdave/6200m-micropolis-fw.tar which also contains the Adaptech drivers you need to create the boot floppy for the upgrade. Good luck. Dave Bodenstab imdave@mcs.net To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message