From owner-freebsd-questions Mon Nov 19 9: 4: 2 2001 Delivered-To: freebsd-questions@freebsd.org Received: from cs.cmu.edu (CS.CMU.EDU [128.2.222.173]) by hub.freebsd.org (Postfix) with SMTP id B724A37B416 for ; Mon, 19 Nov 2001 09:03:59 -0800 (PST) Received: from PIPER.NECTAR.CS.CMU.EDU by cs.cmu.edu id aa00054; 19 Nov 2001 12:03 EST From: davide+freebsd@cs.cmu.edu To: FreeBSD-questions@freebsd.org Reply-To: FreeBSD-questions@freebsd.org Subject: Re: ThinkPad install can't find ep(4) driver In-Reply-To: <20011119013922.L69555@blossom.cjclark.org> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-ID: <22722.1006189432.1@piper.nectar.cs.cmu.edu> Date: Mon, 19 Nov 2001 12:03:52 -0500 Message-ID: <22723.1006189432@piper.nectar.cs.cmu.edu> Sender: owner-freebsd-questions@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.ORG > > Is it possible that this "compression" includes removing the > > ep driver? > Nope. It's on there. How could I verify that? Why would it not show up in UserConfig along with the drivers for other network hardware (which I *don't* have)? According to http://www.freebsd.org/doc/en_US.ISO8859-1/books/handbook/install-start.html I should expect driver conflicts when I enter UserConfig because "all the drivers are enabled, and as has already been explained, some of them will conflict with one another". Indeed all the network devices I don't have are enabled and conflict with each other (and the PCMCIA slot controller, I think it is pcic0). > Are you getting asked about whether you want to use PCCARD devices > for installation media right after the kernel boots? Yes. > How are you configuring things there? It thinks for a moment or two and then starts asking me various configuration questions--disk partitioning, how to divvy up the FreeBSD partition, what I want to install--it does not give me a chance to enter IP addresses, gateway, etc. What would be the best diagnostic information I could provide (hopefully without typing in the entire boot sequence output)? How could I make sure the installation kernel contains the ep driver? Dave Eckhardt To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message