Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 15 Apr 2008 08:41:00 -0300
From:      Felipe Neuwald <felipe@neuwald.biz>
To:        Volker <volker@vwsoft.com>, freebsd-i386@FreeBSD.org
Subject:   Re: i386/122572: FreeBSD 7.0 doesn't install on Dell PowerEdge SC1435
Message-ID:  <4804944C.3080205@neuwald.biz>
In-Reply-To: <4803C779.3030806@vwsoft.com>
References:  <4803C779.3030806@vwsoft.com>

next in thread | previous in thread | raw e-mail | index | archive | help
Volker escreveu:
> Felipe,
>
>   
>> atapci0: <ServerWorks HT1000 SATA150 controller> port 0xecb0-0xecb7,0xeca0-0xeca3,0xecb8-0xecbf,0xeca4-0xeca7,0xece0-0xecef mem 0xefcfe000-0xefcfffff irq 6 at device 14.0 on pci3
>> ad4: DMA limited to UDMA33, device found non-ATA66 cable
>> ad4: 152587MB <WDC WD1600JS-75NCB3 10.02E04> at ata2-master UDMA33
>> ...
>> ad4: TIMEOUT - WRITE_DMA retrying (1 retry left) LBA=532895
>> ad4: TIMEOUT - WRITE_DMA retrying (0 retries left) LBA=532895
>> ad4: FAILURE - WRITE_DMA timed out LBA=532895
>> g_vfs_done():ad4s1a[WRITE(offset=272809984, length=98304)]error = 5
>>     
>
> I just noticed these messages. There have been some HT1000 problems
> shortly before 7.0-RELEASE. My memory does not serve me a known
> workaround but I'll check for it (or have someone else check that).
>
> Do you have the chance to change the SATA controller?
>
> Thanks
>
> Volker
>
>   
Volker,

So, it's HT1000 problem? I cannot change right now, but I'm considering 
to change to a perc5/i.

Thanks,

Felipe Neuwald.



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?4804944C.3080205>