Date: Wed, 9 Jan 2008 11:33:33 +0200 From: "Eimar Koort" <eimar.koort@gmail.com> To: freebsd-hardware@freebsd.org Cc: Alexandr Rybalko <ray@dlink.ua> Subject: Re: ZTE MG478 usbmodem Message-ID: <109c90a0801090133o5d64e943s6c1879a15291dde4@mail.gmail.com> In-Reply-To: <109c90a0801082250r70fc1c43l4bcf27840ab45faf@mail.gmail.com> References: <109c90a0801061055s3c028b06j488d9bdb3419d2f6@mail.gmail.com> <200801062342.59891.hselasky@c2i.net> <109c90a0801062205s6d12e608y59095d703d6eec1c@mail.gmail.com> <20080108110918.6fdd9f3b.ray@dlink.ua> <109c90a0801082250r70fc1c43l4bcf27840ab45faf@mail.gmail.com>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi,
Just to be correct. Below should be:
/usr/src/sys/dev/usb/usbdevs
/usr/src/sys/dev/usb/usb_quircs.c
No luck at all.
> What i did:
> added two lines to /usr/src/sys/usb/usbdevs
>
> vendor ZTE 0x19d2 ZTE
> product ZTE MG478 0xfffe ZTE CDMA2000
>
> Added to /usr/src/sys/usb/usb_quircs.c
> { USB_VENDOR_ZTE, USB_PRODUCT_ZTE_MG478, ANY { UQ_ASSUME_CM_OVER_DATA }},
>
> In kernel config added following:
>
> device umodem
> device ucom
>
> New kernel and after connecting device:
>
> uhub0: device problem (SET_ADDR_FAILED), disabling port 1
> ugen0: ZTE, Incorporated ZTE CDMA Tech, rev 1.10/0.00, addr 2
>
> laptop# usbdevs -v
> Controller /dev/usb0:
> addr 1: full speed, self powered, config 1, UHCI root hub(0x0000),
> Intel(0x0000), rev 1.00
> port 1 addr 2: full speed, self powered, config 1, ZTE CDMA Tech(0xfffe),
> ZTE, Incorporated(0x19d2), rev 0.00
> port 2 powered
>
> Any ideas?
>
--
Eimar Koort
( eimar.koort@gmail.com )
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?109c90a0801090133o5d64e943s6c1879a15291dde4>