Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 16 Mar 1999 21:53:46 -0800 (PST)
From:      Matthew Jacob <mjacob@feral.com>
To:        alpha@freebsd.org
Subject:   Alpha FreeBSD badness (fwd)
Message-ID:  <Pine.LNX.4.04.9903162151260.12815-100000@feral-gw>

next in thread | raw e-mail | index | archive | help

Wierd. I was running NetBSD-alpha/current on this machine. Then I halted
it and booted FreeBSD-alpha.  It blew up in cia_bwx_inw. It only worked
again after I did an 'init' at the SRM prompt.

It looks like state is a bit sticky!



---------- Forwarded message ----------
Date: Tue, 16 Mar 1999 21:49:06 -0800 (PST)
From: Matthew Jacob <mjacob@feral.com>
To: Matthew Jacob <mjacob@feral.com>
Subject: Alpha FreeBSD badness (fwd)


even more:
isp1: <Qlogic ISP 2100 PCI FC-AL Adapter> rev 0x02 int a irq 3 on pci0.9.0
isp1: using I/O space register mapping

unexpected machine check:

    mces    = 0x1
    vector  = 0x660
    param   = 0xfffffc0000006060
    pc      = 0xfffffc00004d7638
    ra      = 0xfffffc00004d7610
    curproc = 0

panic: machine check
panic
Stopped at      Debugger..ng+0x24:      ldq     ra,0(sp)
<0xfffffc0000621990>   <ra=0xfffffc00004c63d8,sp=0xfffffc0000621990>




---------- Forwarded message ----------
Date: Tue, 16 Mar 1999 21:43:51 -0800
From: Matthew Jacob <mjacob@feral.com>
To: mjacob@feral.com
Subject: Alpha FreeBSD badness


unexpected machine check:

    mces    = 0x1
    vector  = 0x660
    param   = 0xfffffc0000006060
    pc      = 0xfffffc00004d7838
    ra      = 0xfffffc00004d7810
    curproc = 0

panic: machine check
panic
Stopped at      Debugger..ng+0x24:      ldq     ra,0(sp) <0xfffffc00006210e0>   <ra=0xfffffc00004c65d8,sp=0xfffffc00006210e0>
db> 
db> 
db> 
db> t
Debugger..ng() at Debugger..ng+0x24
panic..ng() at panic..ng+0xf0
machine_check..ng() at machine_check..ng+0x1fc
interrupt..ng() at interrupt..ng+0x150
XentInt() at XentInt+0x1c
cia_bwx_inw..ng() at cia_bwx_inw..ng+0x18
(null)() at 0x4
db> machine halt
No such command

---
-
\
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [kernel]...               
/kernel data=0x2682c0+0x2e8c8 syms=[0x8+0x4d820+0x8+0x341ca]
Entering kernel at 0xfffffc00003233a0...
Copyright (c) 1992-1999 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California. All rights reserved.
FreeBSD 4.0-CURRENT #6: Thu Mar  4 09:45:40 PST 1999
    mjacob@farrago.feral.com:/space/sys/compile/FARRAGO
EB164
Digital AlphaPC 164 432 MHz, 432MHz
8192 byte page size, 1 processor.
CPU: EV56 (21164A) major=7 minor=1 extensions=0x1<BWX>
OSF PAL rev: 0x1000800020115
real memory  = 265961472 (259728K bytes)
avail memory = 253714432 (247768K bytes)
Preloaded elf kernel "kernel" at 0xfffffc000061c000.
ccd0-3: Concatenated disk drivers
cia0: <2117x PCI adapter>
cia0: ALCOR/ALCOR2, pass 3
cia0: extended capabilities: 21<DWEN,BWEN>
isa0
Probing for devices on PCI bus 0:
Qlogic ISP Driver, FreeBSD CAM Version 0.98, Core Version 1.6
isp0: <Qlogic ISP 10X0 PCI SCSI Adapter> rev 0x05 int a irq 2 on pci0.5.0
isp0: using I/O space register mapping
isp0: set PCI line size to 16
isp0: Ultra Mode Capable
isp0: Board Revision 1040B, loaded F/W Revision 7.55
isp0: Last F/W revision was 2.10
ncr0: <ncr 53c825 fast10 wide scsi> rev 0x02 int a irq 0 on pci0.6.0
de0: <Digital 21140A Fast Ethernet> rev 0x20 int a irq 1 on pci0.7.0
de0: 21140A [10-100Mb/s] pass 2.0
de0: address 00:c0:f0:16:2d:7c
chip0: <Intel 82378IB PCI to ISA bridge> rev 0x43 on pci0.8.0
isp1: <Qlogic ISP 2100 PCI FC-AL Adapter> rev 0x02 int a irq 3 on pci0.9.0
isp1: using I/O space register mapping
isp1: set PCI line size to 16
isp1: Board Revision 2100, loaded F/W Revision 1.15
isp1: Adapter WWN 0x200000e08b00e100
isp1: Firmware State Config Wait -> Waiting for AL/PA
isp1: Firmware State Waiting for AL/PA -> Wait Login
isp1: Firmware State Wait Login -> Waiting for AL/PA
isp1: isp_mboxcmd timeout #1
isp1: but we'll try again, isr=8008
isp1: Port Database Changed
isp1: Firmware State Waiting for AL/PA -> Ready
isp1: Loop ID 113, ALPA 0x23
mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A, console
atkbdc0: <keyboard controller (i8042)> at port 0x60 on isa0
atkbd0: <AT Keyboard> on atkbdc0
struct nfssvc_sock bloated (> 256bytes)
Try reducing NFS_UIDHASHSIZ
struct nfsuid bloated (> 128bytes)
Try unionizing the nu_nickname and nu_flag fields
Timecounter "alpha"  frequency 432900432 Hz
de0 XXX: driver didn't set ifq_maxlen
Waiting 2 seconds for SCSI devices to settle
isp0: driver initiated bus reset
isp1: driver initiated bus reset
de0: enabling 100baseTX port
isp1: Loop DOWN
(noperiph:isp1:0:-1:-1): freezing SIMQ until loop comes up
(probe59:isp1:0:29:0): isp_done releasing SIMQ
da2 at ncr0 bus 0 target 2 lun 0
da2: <SEAGATE ST12550W 0006> Fixed Direct Access SCSI-2 device 
da2: 20.000MB/s transfers (10.000MHz, offset 8, 16bit), Tagged Queueing
Enabled
da2: 2040MB (4178874 512 byte sectors: 255H 63S/T 260C)
da1 at isp0 bus 0 target 1 lun 0
da1: <SEAGATE ST15230W 0638> Fixed Direct Access SCSI-2 device 
da1: 20.000MB/s transfers (10.000MHz, offset 8, 16bit), Tagged Queueing
Enabled
da1: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C)
da0 at isp0 bus 0 target 0 lun 0
da0: <IBM DORS-32160W WA6A> Fixed Direct Access SCSI-2 device 
da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing
Enabled
da0: 2063MB (4226725 512 byte sectors: 255H 63S/T 263C)
WARNING: clock gained 12 days -- CHECK AND RESET THE DATE!
Start pid=2 <pagedaemon>
Start pid=3 <vmdaemon>
Start pid=4 <syncer>
swapon: adding /dev/da1b as swap device
Automatic reboot in progress...
/dev/rda1a: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/rda1a: clean, 3227299 free (34115 frags, 399148 blocks, 0.9%
fragmentation)
Doing initial network setup: hostname domain.
de0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet 192.67.166.23 netmask 0xffffff00 broadcast 192.67.166.255
        ether 00:c0:f0:16:2d:7c 
        media: autoselect (100baseTX) status: active
        supported media: autoselect 100baseTX <full-duplex> 100baseTX
10baseT/UTP <full-duplex> 10baseT/UTP
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet 127.0.0.1 netmask 0xff000000 

add net default: gateway 192.67.166.126
Additional routing options: tcp extensions=NO.
routing daemons:.
Mounting NFS file systems.
recording kernel -c changes
additional daemons: syslogd.
Doing additional network setup: ntpdate xntpd portmap ypbind.
Starting final network daemons: nfsiod.
setting ELF ldconfig path: /usr/lib /usr/lib/compat /usr/local/lib
setting a.out ldconfig path: /usr/lib/aout /usr/lib/compat/aout
ldconfig: illegal option -- a
usage: ldconfig [-Rmrsv] [-f hints_file] [dir | file ...]
starting standard daemons: inetd cron.
Initial rc.alpha initialization:.
rc.alpha configuring syscons: blank_time/etc/rc.alpha: cannot open
/dev/ttyv0: no such device or address
.
Local package initialization:.
starting local daemons:.
vfs.ffs.doreallocblks: 1 -> 0
Tue Mar 16 21:51:33 PST 1999

FreeBSD/alpha (farrago.feral.com) (ttyd0)

login: isp1: LIP occurred
isp1: Loop UP
(noperiph:isp1:0:-1:-1): isp1: Port Database Changed




To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.LNX.4.04.9903162151260.12815-100000>