Skip site navigation (1)Skip section navigation (2)
Date:      Sat, 08 Jun 2013 22:54:44 +0300
From:      Sasha and Tanya Kapshuk <sashaandtanya@gmail.com>
To:        Warren Block <wblock@wonkity.com>
Cc:        freebsd-questions@freebsd.org
Subject:   Re: trouble setting up wireless [AR2425]
Message-ID:  <51B38C04.50706@gmail.com>
In-Reply-To: <alpine.BSF.2.00.1306081231490.63741@wonkity.com>
References:  <51B35217.9080003@gmail.com> <alpine.BSF.2.00.1306081202210.63741@wonkity.com> <51B37351.4060709@gmail.com> <alpine.BSF.2.00.1306081231490.63741@wonkity.com>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
On 06/08/2013 09:33 PM, Warren Block wrote:
> On Sat, 8 Jun 2013, Sasha and Tanya Kapshuk wrote:
>
>> On 06/08/2013 09:03 PM, Warren Block wrote:
>>>
>>>> Howdy,
>>>>
>>>> Been trying to setup wireless on a laptop with an Atheros 5424/2424 
>>>> card running FreeBSD 9.1-RELEASE.
>>>>
>>>> Been following the instructions given in the handbook.
>>>>
>>>> Running 'ifconfig wlan0 up scan' does not seem to return anything. 
>>>> What am I doing wrong?
>>>
>>> That should be 'ifconfig wlan0 up list scan'. 
>> Tried that. Still no output.
>>
>> I see that my card being identified as AR2425 is supported by the 
>> ath_hal(4) module. How do I enable it?
>
> Both are built into the GENERIC kernel.  If you've built a custom 
> kernel, you'll have to load them in /boot/loader.conf.
>
>> Here's whta I've got in my /etc/rc.conf:
>>
>> if_ath_load="YES"
>> if_ath_pci_load="YES"
>
> Right, but those go in /boot/loader.conf.  Not needed if you're using 
> the GENERIC kernel, though.
>
>> ifconfig says 'no carrier' for wlan0.
>
> Here's my "short form" wireless article:
>
> http://www.wonkity.com/~wblock/docs/html/wireless.html



dmesg|grep wlan0

wlan0:    promiscuous mode enabled
wlan0:    promiscuous mode disabled

Is that a bug in the ath driver?

Thanks.




Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?51B38C04.50706>