Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 26 Dec 2002 16:48:06 -0500 (EST)
From:      Trevor Johnson <trevor@jpj.net>
To:        alpha@freebsd.org
Cc:        "David O'Brien" <obrien@freebsd.org>
Subject:   5.0-RC2 on Alphaserver 4100 mostly a success
Message-ID:  <20021226162035.I19983-100000@blues.jpj.net>

next in thread | raw e-mail | index | archive | help
I did a fresh installation, booting from floppy then downloading via FTP
from another computer on the same Fast Ethernet hub.  The one problem I
noticed is that the files transferred slowly by FTP, at less than 10
kilobytes per second.  After the installation, getting files over FTP is
still just as slow.  When I tried doing "dd if=/dev/zero of=/tmp/zero
bs=128k count=500", dd reported a rate of 5611025 bytes per second, so the
trouble doesn't seem to be a slow disk drive.  When I tried sending the
file that I made with dd from the Alpha to the other computer, it went at
a more respectable speed of around 300 kilobytes per second (this while
other people were using the network--it was quiet when I did the
installation).

-- show device --
polling ncr0 (NCR 53C810) slot 1, bus 0 PCI, hose 1   SCSI Bus ID 7
dka500.5.0.1.1     DKA500                   RRD45  0436
mka600.6.0.1.1     MKA600                   TLZ07  553B
polling isp0 (QLogic ISP10X0) slot 0, bus 2 PCI, hose 1   SCSI Bus ID 7
polling floppy0 (FLOPPY) PCEB - XBUS hose 0
dva0.0.0.1000.0    DVA0                      RX23
polling ncr1 (NCR 53C825) slot 3, bus 0 PCI, hose 0   SCSI Bus ID 7
dkc0.0.0.3.0       DKC0                     SEAGATE ST15230N  0252
dkc100.1.0.3.0     DKC100                   SEAGATE ST15230N  0252
dkc200.2.0.3.0     DKC200                   SEAGATE ST15230N  0252
dkc300.3.0.3.0     DKC300                   SEAGATE ST15230N  0638
dkc400.4.0.3.0     DKC400                   SEAGATE ST15230N  0638
dkc600.6.0.3.0     DKC600                   SEAGATE ST15230N  0638
polling tulip0 (DECchip 21140-AA) slot 2, bus 0 PCI, hose 1
ewa0.0.0.2.1       00-00-F8-00-3C-EC    FastFD (Full Duplex)

-- dmesg --
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-RC2 #0: Wed Dec 18 17:06:35 GMT 2002
    root@mithlond.btc.adaptec.com:/usr/obj/usr/src/sys/GENERIC
Preloaded elf kernel "/boot/kernel/kernel" at 0xfffffc0000844000.
AlphaServer 4100
AlphaServer 4100 5/300 2MB, 299MHz
8192 byte page size, 2 processors.
CPU: EV5 (21164) major=5 minor=5
OSF PAL rev: 0x4000200020117
real memory  = 534757376 (509 MB)
avail memory = 512491520 (488 MB)
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
Initializing GEOMetry subsystem
mcbus0: <MCBUS Backplane Bus>
pcib0: <MCPCIA PCI Adapter> at mcbus0 gid 7 mid 5
pcib0: Horse Revision 3, Left Handed Saddle Revision 3, CAP Revision 2
pci0: <PCI bus> on pcib0
sym0: <810> port 0x1ffee00-0x1ffeeff mem 0x7effe00-0x7effeff irq 4 at device 1.0 on pci0
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
sym0: interrupting at IRQ 0x10 intA (vec 0xb40)
de0: <Digital 21140 Fast Ethernet> port 0x1ffef00-0x1ffef7f mem 0x7efff00-0x7efff7f irq 8 at device 2.0 on pci0
de0: interrupting at IRQ 0x0 intA (vec 0xb80)
de0: DEC DE500-XA 21140 [10-100Mb/s] pass 1.1
de0: address 00:00:f8:00:3c:ec
de0: enabling Full Duplex 100baseTX port
pcib2: <PCI-PCI bridge> at device 5.0 on pci0
pci2: <PCI bus> on pcib2
isp0: <Qlogic ISP 1020/1040 PCI SCSI Adapter> port 0x1ffff00-0x1ffffff mem 0x7fef000-0x7feffff irq 20 at device 0.0 on pci2
isp0: interrupting at IRQ 0xc intA (vec 0xc40)
pcib1: <MCPCIA PCI Adapter> at mcbus0 gid 7 mid 4
pcib1: Horse Revision 3, Left Handed Saddle Revision 3, CAP Revision 2
pci1: <PCI bus> on pcib1
eisab0: <PCI-EISA bridge> at device 1.0 on pci1
isa0: <ISA bus> on eisab0
pci1: <unknown> at device 2.0 (no driver attached)
sym1: <825a> port 0x1ffff00-0x1ffffff mem 0x77e7000-0x77e7fff,0x77e6f00-0x77e6fff irq 12 at device 3.0 on pci1
sym1: No NVRAM, ID 7, Fast-10, SE, parity checking
sym1: interrupting at IRQ 0x4 intA (vec 0x9c0)
ata0 at port 0x3f6,0x1f0-0x1f7 irq 14 on isa0
ata0: interrupting at ISA irq 14
ata1 at port 0x376,0x170-0x177 irq 15 on isa0
ata1: interrupting at ISA irq 15
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
atkbd0: interrupting at ISA irq 1
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
fdc0: interrupting at ISA irq 6
mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
ppc0: <Parallel port> at port 0x3bc-0x3c3 irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
lpt0: <Printer> on ppbus0
lpt0: Polled port
ppi0: <Parallel I/O> on ppbus0
ppc0: interrupting at ISA irq 7
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x0>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A, console
sio0: interrupting at ISA irq 4
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
sio1: interrupting at ISA irq 3
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 0.833 msec
Timecounter "i8254"  frequency 1193182 Hz
Waiting 15 seconds for SCSI devices to settle
sa0 at sym0 bus 0 target 6 lun 0
sa0: <DEC TLZ07     (C)DEC 553B> Removable Sequential Access SCSI-2 device
sa0: 7.812MB/s transfers (7.812MHz, offset 8)
cd0 at sym0 bus 0 target 5 lun 0
cd0: <DEC RRD45   (C) DEC 0436> Removable CD-ROM SCSI-2 device
cd0: 4.237MB/s transfers (4.237MHz, offset 8)
cd0: cd present [584584 x 512 byte records]
da0 at sym1 bus 0 target 0 lun 0
da0: <SEAGATE ST15230N 0252> Fixed Direct Access SCSI-2 device
da0: 10.000MB/s transfers (10.000MHz, offset 8), Tagged Queueing Enabled
da0: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C)
da1 at sym1 bus 0 target 1 lun 0
da1: <SEAGATE ST15230N 0252> Fixed Direct Access SCSI-2 device
da1: 10.000MB/s transfers (10.000MHz, offset 8), Tagged Queueing Enabled
da1: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C)
da2 at sym1 bus 0 target 2 lun 0
da2: <SEAGATE ST15230N 0252> Fixed Direct Access SCSI-2 device
da2: 10.000MB/s transfers (10.000MHz, offset 8), Tagged Queueing Enabled
da2: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C)
da3 at sym1 bus 0 target 3 lun 0
da3: <SEAGATE ST15230N 0638> Fixed Direct Access SCSI-2 device
da3: 10.000MB/s transfers (10.000MHz, offset 8), Tagged Queueing Enabled
da3: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C)
da4 at sym1 bus 0 target 4 lun 0
da4: <SEAGATE ST15230N 0638> Fixed Direct Access SCSI-2 device
da4: 10.000MB/s transfers (10.000MHz, offset 8), Tagged Queueing Enabled
da4: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C)
da5 at sym1 bus 0 target 6 lun 0
da5: <SEAGATE ST15230N 0638> Fixed Direct Access SCSI-2 device
da5: 10.000MB/s transfers (10.000MHz, offset 8), Tagged Queueing Enabled
da5: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C)
SMP: AP CPU #1 Launched!
Mounting root from ufs:/dev/da0a
-- 
Trevor Johnson



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20021226162035.I19983-100000>