Date: Fri, 9 Feb 2001 22:27:35 -0500 From: Barney Wolff <barney@databus.com> To: hardware@freebsd.org Subject: Supermicro PIIIDRE Message-ID: <20010209222735.A54850@mx.databus.com>
next in thread | raw e-mail | index | archive | help
I'm running 4.2-stable on a Supermicro PIIIDRE with good success. -j4 buildworld in 28 min with 2 1GHz cpu's and 2 10,000 rpm scsi drives. Does anyone know if there is support for the onboard AC'97 sound in the Intel 82801AA? I got from somewhere that it has a CS4299 codec, which does not seem to be among the chips that csa.c supports. (Devices pcm and csa are in the kernel config.) Also, I'm running healthd through the smbus, but get only a chipset temp, not the two cpu temps. Does anyone have a magic healthd.conf that works with this motherboard? If not I guess I'll plow through the Winbond datasheet and report results. Finally, can anyone point me to a reference for the unknown PNP devices? I have the BIOS set for "plug&play os" - is that right? There are no ISA slots, and only a 39160 in the PCI slots, with an ATI Radeon in the AGP. Thanks, Barney Wolff dmesg.boot: avail memory = 257232896 (251204K bytes) Programming 24 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 Programming 24 pins in IOAPIC #1 IOAPIC #1 intpin 0 -> irq 2 IOAPIC #1 intpin 1 -> irq 18 FreeBSD/SMP: Multiprocessor motherboard cpu0 (BSP): apic id: 0, version: 0x00040011, at 0xfee00000 cpu1 (AP): apic id: 1, version: 0x00040011, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00170020, at 0xfec00000 io1 (APIC): apic id: 3, version: 0x00178020, at 0xff6fd000 Preloaded elf kernel "kernel" at 0xc03ee000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc03ee09c. Pentium Pro MTRR support enabled md0: Malloc disk npx0: <math processor> on motherboard npx0: INT 16 interface pcib0: <Host to PCI bridge> on motherboard pci0: <PCI bus> on pcib0 pcib1: <PCI to PCI bridge (vendor=8086 device=1a23)> at device 1.0 on pci0 pci4: <PCI bus> on pcib1 pci4: <ATI model 5144 graphics accelerator> at 0.0 irq 16 pcib2: <PCI to PCI bridge (vendor=8086 device=1a24)> at device 2.0 on pci0 pci2: <PCI bus> on pcib2 pcib3: <PCI to PCI bridge (vendor=8086 device=1360)> at device 31.0 on pci2 pci3: <PCI bus> on pcib3 pci3: <unknown card> (vendor=0x8086, dev=0x1161) at 0.0 ahc0: <Adaptec 3960D Ultra160 SCSI adapter> port 0xb400-0xb4ff mem 0xff6fe000-0x ff6fefff irq 2 at device 2.0 on pci3 aic7899: Wide Channel A, SCSI Id=7, 32/255 SCBs ahc1: <Adaptec 3960D Ultra160 SCSI adapter> port 0xb800-0xb8ff mem 0xff6ff000-0x ff6fffff irq 18 at device 2.1 on pci3 aic7899: Wide Channel B, SCSI Id=7, 32/255 SCBs pcib4: <Intel 82801AA (ICH) Hub to PCI bridge> at device 30.0 on pci0 pci1: <PCI bus> on pcib4 fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xaf00-0xaf3f mem 0xff400000-0xff4f ffff,0xff5fe000-0xff5fefff irq 16 at device 8.0 on pci1 fxp0: Ethernet address 00:30:48:10:70:d5 isab0: <Intel 82801AA (ICH) PCI to LPC bridge> at device 31.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <Intel ICH ATA66 controller> port 0xffa0-0xffaf at device 31.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 uhci0: <Intel 82801AA (ICH) USB controller> port 0xef80-0xef9f irq 19 at device 31.2 on pci0 usb0: <Intel 82801AA (ICH) USB controller> on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered ichsmb0: <Intel 82801AA (ICH) SMBus controller> port 0xefa0-0xefaf irq 17 at dev ice 31.3 on pci0 smbus0: <System Management Bus> on ichsmb0 smb0: <SMBus general purpose I/O> on smbus0 chip1: <Intel 82801AA (ICH) AC'97 Audio Controller> port 0xef00-0xef3f,0xe800-0x e8ff irq 17 at device 31.5 on pci0 fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> on fdc0 drive 0 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 kbd0 at atkbd0 psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: model Generic PS/2 mouse, device ID 0 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode ppc0: FIFO with 16/16/8 bytes threshold ppi0: <Parallel I/O> on ppbus0 plip0: <PLIP network interface> on ppbus0 lpt0: <Printer> on ppbus0 lpt0: Interrupt-driven port unknown: <PNP0303> can't assign resources unknown: <PNP0501> can't assign resources unknown: <PNP0501> can't assign resources unknown: <PNP0401> can't assign resources unknown: <PNP0700> can't assign resources unknown: <PNP0f13> can't assign resources APIC_IO: Testing 8254 interrupt delivery APIC_IO: routing 8254 via IOAPIC #0 intpin 2 IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging limited to 100 packets/entry by default IPsec: Initialized Security Association Processing. IP Filter: v3.4.8 initialized. Default = pass all, Logging = enabled SMP: AP CPU #1 Launched! acd0: CDROM <SONY CDU4811> at ata0-master using PIO4 acd1: CD-RW <SONY CD-RW CRX140E> at ata0-slave using UDMA33 Waiting 10 seconds for SCSI devices to settle Mounting root from ufs:/dev/da0s2a da0 at ahc0 bus 0 target 0 lun 0 da0: <SEAGATE ST318404LC 0006> Fixed Direct Access SCSI-3 device da0: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing Enable d da0: 17501MB (35843670 512 byte sectors: 255H 63S/T 2231C) da1 at ahc0 bus 0 target 1 lun 0 da1: <SEAGATE ST318404LC 0006> Fixed Direct Access SCSI-3 device da1: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing Enable d da1: 17501MB (35843670 512 byte sectors: 255H 63S/T 2231C) To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-hardware" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010209222735.A54850>