Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 11 Feb 2011 09:44:05 -0500
From:      Nathan Vidican <nathan@vidican.com>
To:        Guillermo Fernando Cotone <guillermo.cotone@gmail.com>
Cc:        freebsd-questions@freebsd.org
Subject:   Re: how to add a few hundred ip on one interface?
Message-ID:  <AANLkTinPOU-RMv3FHTtNYiy_g-S_As292fpfPm79WEtS@mail.gmail.com>
In-Reply-To: <4D5538DF.2050309@gmail.com>
References:  <4D547675.60506@ukr.net> <AANLkTikQ10rJ5up-idYadytaa3xCJpQCXGYQTe5YaFMF@mail.gmail.com> <4D54D22F.2060607@infracaninophile.co.uk> <4D5531D3.8040906@ukr.net> <4D5538DF.2050309@gmail.com>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
On Fri, Feb 11, 2011 at 8:25 AM, Guillermo Fernando Cotone <
guillermo.cotone@gmail.com> wrote:

> On 02/11/2011 09:55 AM, Vladislav V. Prodan wrote:
> > And this construction work?
> >
> >       ipv4_addrs_ed0="192.0.2.129/27 192.0.2.1-2/28 192.0.2.4-5/28"
> >
> It would work only if all the IPs were on the same subnet. If you want
> to use different subnets you need to implement vlans on that interface
> first.
>
> Regards,
> Guillermo
>
>
Implementing vlans makes an assumption that the network in question already
does too. Though I agree, that in practice multiple subnets should not be on
the same ethernet segment, it is not technically impossible. The correct
response was quoted from the rc.conf manpage per the other response already
sent. VLAN implementation is a whole different setup.

-- 
Nathan Vidican
nathan@vidican.com



Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?AANLkTinPOU-RMv3FHTtNYiy_g-S_As292fpfPm79WEtS>