Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 19 Dec 2007 16:31:00 +0900
From:      "Hidetoshi Shimokawa" <simokawa@FreeBSD.ORG>
To:        "Wojciech A. Koszek" <wkoszek@freebsd.org>, freebsd-current@freebsd.org,  simokawa@freebsd.org
Subject:   Re: FireWire causes hang at boot
Message-ID:  <626eb4530712182331o38e3cdfem8899302dfb7b2e4a@mail.gmail.com>
In-Reply-To: <20071219025024.GA6966@FreeBSD.czest.pl>
References:  <20071219025024.GA6966@FreeBSD.czest.pl>

next in thread | previous in thread | raw e-mail | index | archive | help
Oops, could you replace the line "u_int max_node;" in firewirereg.h
with  "int max_node;".
This should prevent too many loops. However, I don't know why we cannot
get correct max_node value from self-id packets.

Thanks,

On 12/19/07, Wojciech A. Koszek <wkoszek@freebsd.org> wrote:
> Hello,
>
> This report is about -CURRENT (20071217).  Kernel on my ASUS A7N8X
> motherboard (with FireWire controller) hangs after disk has been
> detected and GEOM_LABEL labels are probed:
>
> GEOM: new disk ad2
> ad2: nVidia check1 failed
> ad2: Adaptec check1 failed
> ad2: LSI (v3) check1 failed
> ad2: LSI (v2) check1 failed
> ad2: FreeBSD check1 failed
> GEOM_LABEL: Label for provider ad2s2a is label/daemon.fs.
> GEOM_LABEL: Label for provider ad2s2b is label/daemon.swap.
>
> <hang>
>
> Sometimes, if I plug and unplug the FireWire cable (several times), boot
> continues. Hardware:
>
> fwohci0: <1394 Open Host Controller Interface> mem 0xe8086000-0xe80867ff,0xe8087000-0xe808703f irq 9 at device 13.0 on pci0
> fwohci0: [FILTER]
> fwohci0: OHCI version 1.10 (ROM=0)
> fwohci0: No. of Isochronous channels is 4.
> fwohci0: EUI64 00:e0:18:00:00:6c:d5:4a
> fwohci0: Phy 1394a available S400, 2 ports.
> fwohci0: Link S400, max_rec 2048 bytes.
> firewire0: <IEEE1394(FireWire) bus> on fwohci0
> dcons_crom0: <dcons configuration ROM> on firewire0
> dcons_crom0: bus_addr 0xbf6460
> fwe0: <Ethernet over FireWire> on firewire0
> if_fwe0: Fake Ethernet address: 02:e0:18:6c:d5:4a
> fwe0: Ethernet address: 02:e0:18:6c:d5:4a
> fwip0: <IP over FireWire> on firewire0
> fwip0: Firewire address: 00:e0:18:00:00:6c:d5:4a @ 0xfffe00000000, S400, maxrec 2048
> sbp0: <SBP-2/SCSI over FireWire> on firewire0
> fwohci0: Initiate bus reset
> fwohci0: BUS reset
> fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
>
> After reboot, I jumped to the debugger, set firewire_debug = 1 and this
> time I saw a huge number of messages coming from:
>
>         static void
>         fw_explore(struct firewire_comm *fc):
>
> Citation of firewire.c:
>
> [cut]
>
>         for (node = 0; node <= fc->max_node; node ++) {
>                 /* We don't probe myself and linkdown nodes */
>                 if (node == fc->nodeid)
>                         continue;
>                 fwsid = fw_find_self_id(fc, node);
>                 if (!fwsid || !fwsid->p0.link_active) {
>                         if (firewire_debug)
>                                 printf("node%d: link down\n", node);
>                         continue;
>                 }
>                 nodes[todo++] = node;
>         }
>
> [cut]
>
> It's iterating infinitely on my system. I set some breakpoints and:
>
> db> c
> node258: link down
> [thread pid 19 tid 100030 ]
> Breakpoint at   fw_bus_probe_thread+304:        addl    $1,4294966116(%ebp)
> db> step
> [thread pid 19 tid 100030 ]
> Stopped at      fw_bus_probe_thread+311:        movl    4294966116(%ebp),%ecx
> db> step
> [thread pid 19 tid 100030 ]
> Stopped at      fw_bus_probe_thread+317:        movl    4294966104(%ebp),%eax
> db> step
> [thread pid 19 tid 100030 ]
> Stopped at      fw_bus_probe_thread+323:        cmpl    %ecx,32(%eax)
> db> step
> [thread pid 19 tid 100030 ]
> Stopped at      fw_bus_probe_thread+326:        jnb     fw_bus_probe_thread+192
> db> p/x $eax
> c2eda000              <- fc
> db> p/x $eax+32
> c2eda020              <- fc->max_node
> db> p/x *0xc2eda020
> ffffffff              <- it looks like it's wrong
>
> db> p/x $ecx
>      103
> db> p/d $ecx          <- it's "node" it that context.
>         259
>
>
> --
> Wojciech A. Koszek
> wkoszek@FreeBSD.org
> http://FreeBSD.czest.pl/dunstan/
>
>


-- 
/\ Hidetoshi Shimokawa
\/  simokawa@FreeBSD.ORG



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?626eb4530712182331o38e3cdfem8899302dfb7b2e4a>