Skip site navigation (1)Skip section navigation (2)
Date:      Sat, 5 Oct 1996 11:58:38 +0200 (MET DST)
From:      grog@lemis.de (Greg Lehey)
To:        bartling@cyrix.com (Steve Bartling)
Cc:        questions@FreeBSD.org (FreeBSD Questions)
Subject:   Re: Irwin ( exabyte 8200 ) and Freebsd 2.1.5
Message-ID:  <199610050958.LAA08632@allegro.lemis.de>
In-Reply-To: <9610031817.AA04092@mega.cyrix.com> from "Steve Bartling" at Oct 3, 96 01:17:20 pm

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
Steve Bartling writes:
>
> I have two tape drives installed. An Archive 2150s is present
> on SCSI ID 4. The 8200 is installed on ID 5.
>
> I created the proper devices in /dev using the "/dev/MAKEDEV st1"
> command. All of the proper devices were created.
>
> I rebooted just to make sure everything was clean and verified
> that Freebsd properly probed/detected the 8200 and attached it
> to the st1 interface. The Archive 2150s was also properly identified
> and was attached to st0.
>
> Now for the problem ...
>
> The Archive 2150s works fine. When I attempt to "tar -cvf /dev/rst1"
> the entire SCSI bus hangs, requiring a machine boot to clear the
> bus. I cannot use the st or the mt utilities to display status or
> set modes. When I attempt to do so, I get "Invalid Input/Output Error".
>
> Again, I can access the 2150s just fine. Hardware does not seem to be
> at fault since both drives are happy under DOS.
>
> Any clues ?

Not much.  I'd have guessed termination, but that should bite you
under DOS as well.  Have you checked the termination?  Have you tried
removing the Archive drive?

Greg



Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?199610050958.LAA08632>