Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 01 Apr 2005 14:00:00 -0500
From:      Mike Tancsa <mike@sentex.net>
To:        "Gray Lilley" <gray@mistaken-identity.co.uk>, <freebsd-stable@freebsd.org>
Subject:   RE: RELENG_5 problems with Intel 855 (RELENG_4 boots fine) (solved!)
Message-ID:  <6.2.1.2.0.20050401135639.047d9138@64.7.153.2>
In-Reply-To: <ACE436445E3CB14DB6B6DF23AB5D72DB8280@magnum.Home.local>
References:  <ACE436445E3CB14DB6B6DF23AB5D72DB8280@magnum.Home.local>

next in thread | previous in thread | raw e-mail | index | archive | help
At 01:29 PM 01/04/2005, Gray Lilley wrote:
>Can you try setting hw.pci.enable_io_modes=0 at the loader prompt then 
>booting?

Thanks!  That did the trick!!

OK set hw.pci.enable_io_modes=0
OK boot
/boot/kernel/acpi.ko text=0x41520 data=0x1da4+0x112c 
syms=[0x4+0x7630+0x4+0x9c97]
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2005 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
         The Regents of the University of California. All rights reserved.
FreeBSD 5.4-PRERELEASE #0: Fri Apr  1 09:06:22 EST 2005
     mdtancsa@nfs.sentex.ca:/usr/obj/usr/src/sys/nfs
ACPI APIC Table: <AOpen  AWRDACPI>
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Celeron(R) M processor         1500MHz (1500.06-MHz 686-class 
CPU)
   Origin = "GenuineIntel"  Id = 0x695  Stepping = 5
   Features=0xa7e9fbbf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,TM,PBE>
real memory  = 534642688 (509 MB)
avail memory = 513507328 (489 MB)
ioapic0 <Version 2.0> irqs 0-23 on motherboard
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <AOpen AWRDACPI> on motherboard
acpi0: Power Button (fixed)
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x4008-0x400b on acpi0
cpu0: <ACPI CPU (3 Cx states)> on acpi0
acpi_throttle0: <ACPI CPU Throttling> on cpu0
acpi_button0: <Power Button> on acpi0
acpi_button1: <Sleep Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pci0: <base peripheral> at device 0.1 (no driver attached)
pci0: <base peripheral> at device 0.3 (no driver attached)
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
agp0: <Intel 82855GME (855GME GMCH) SVGA controller> port 0xe300-0xe307 mem 
0xed000000-0xed07ffff,0xe0000000-0xe7ffffff irq 16 at device 2.0 on pci0
agp0: detected 892k stolen memory
agp0: aperture size is 128M
pci0: <display> at device 2.1 (no driver attached)
pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib2
puc0: <Lava Computers Quattro-PCI serial port> port 
0xd300-0xd307,0xd200-0xd207 irq 16 at device 4.0 on pci2
sio4: <Lava Computers Quattro-PCI serial port> on puc0
sio4: type 16550A
sio4: unable to activate interrupt in fast mode - using normal mode
sio5: <Lava Computers Quattro-PCI serial port> on puc0
sio5: type 16550A
sio5: unable to activate interrupt in fast mode - using normal mode
puc1: <Lava Computers Quattro-PCI serial port> port 
0xd500-0xd507,0xd400-0xd407 irq 16 at device 4.1 on pci2
sio6: <Lava Computers Quattro-PCI serial port> on puc1
sio6: type 16550A
sio6: unable to activate interrupt in fast mode - using normal mode
sio7: <Lava Computers Quattro-PCI serial port> on puc1
sio7: type 16550A
sio7: unable to activate interrupt in fast mode - using normal mode
pci2: <simple comms, UART> at device 5.0 (no driver attached)
twe0: <3ware Storage Controller. Driver version 1.50.01.002> port 
0xd700-0xd70f mem 0xec000000-0xec7fffff irq 18 at device 6.0 on pci2
twe0: 2 ports, Firmware FE7X 1.05.00.068, BIOS BE7X 1.08.00.048
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH4 UDMA100 controller> port 
0xf000-0xf00f,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 31.1 on pci0
ata0: channel #0 on atapci0
ata1: channel #1 on atapci0
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
acpi_tz0: <Thermal Zone> on acpi0
fdc0: <floppy drive controller> port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0
sio0: <16550A-compatible COM port> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
sio0: type 16550A, console
sio1: <16550A-compatible COM port> port 0x2f8-0x2ff irq 3 on acpi0
sio1: type 16550A
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
pmtimer0 on isa0
orm0: <ISA Option ROM> at iomem 0xd0000-0xd0fff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
ppc0: parallel port not found.
Timecounter "TSC" frequency 1500059900 Hz quality 800
Timecounters tick every 10.000 msec
ipfw2 initialized, divert enabled, rule-based forwarding enabled, default 
to accept, logging limited to 3100 packets/entry by default
ad0: 38166MB <ST340014A/3.06> [77545/16/63] at ata0-master UDMA100
acd0: CDROM <CD-ROM 48X/AKU/T31> at ata1-master PIO4
twed0: <Unit 0, TwinStor, Normal> on twe0
twed0: 76318MB (156299440 sectors)
Mounting root from ufs:/dev/ad0s1a
Pre-seeding PRNG: kickstart.
Loading configuration files.
Entropy harvesting: interrupts ethernet point_to_point kickstart.
kernel dumps on /dev/ad0s1b
swapon: adding /dev/ad0s1b as swap device
Starting file system checks:
/dev/ad0s1a: FILE SYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1a: clean, 331086 free (990 frags, 41262 blocks, 0.2% fragmentation)
/dev/ad0s1e: FILE SYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1e: clean, 500291 free (203 frags, 62511 blocks, 0.0% fragmentation)
/dev/ad0s1d: FILE SYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1d: clean, 6260810 free (48418 frags, 776549 blocks, 0.6% 
fragmentation)
/dev/ad0s1f: FILE SYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1f: clean, 9698700 free (252 frags, 1212306 blocks, 0.0% 
fragmentation)
Setting hostname: nfs.sentex.ca.
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
         inet 127.0.0.1 netmask 0xff000000
Flushed all rules.
00100 allow ip from any to any via lo0
00200 deny ip from any to 127.0.0.0/8
00300 deny ip from 127.0.0.0/8 to any
65000 allow ip from any to any
Firewall rules loaded, starting divert daemons:.
Firewall logging enabled
net.inet.ip.fw.enable: 1 -> 1
Additional routing options:.
Starting devd.
Mounting NFS file systems:.
Starting syslogd.
Apr  1 12:07:52 nfs syslogd: kernel boot file is /boot/kernel/kernel 



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?6.2.1.2.0.20050401135639.047d9138>