From owner-freebsd-questions Sun Feb 20 13:31:28 2000 Delivered-To: freebsd-questions@freebsd.org Received: from cc942873-a.ewndsr1.nj.home.com (cc942873-a.ewndsr1.nj.home.com [24.2.89.207]) by hub.freebsd.org (Postfix) with ESMTP id B0E8137BFEA for ; Sun, 20 Feb 2000 13:31:23 -0800 (PST) (envelope-from cjc@cc942873-a.ewndsr1.nj.home.com) Received: (from cjc@localhost) by cc942873-a.ewndsr1.nj.home.com (8.9.3/8.9.3) id QAA36981; Sun, 20 Feb 2000 16:34:15 -0500 (EST) (envelope-from cjc) Date: Sun, 20 Feb 2000 16:34:15 -0500 From: "Crist J. Clark" To: Walt Roberts Cc: freebsd-questions@FreeBSD.ORG Subject: Re: Adaptec 1542c and Exabyte 8200/tar: Device not config Message-ID: <20000220163415.F36373@cc942873-a.ewndsr1.nj.home.com> Reply-To: cjclark@home.com References: <38B019AD.BD0B1B9D@med.wayne.edu> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii X-Mailer: Mutt 1.0i In-Reply-To: <38B019AD.BD0B1B9D@med.wayne.edu>; from wroberts@med.wayne.edu on Sun, Feb 20, 2000 at 11:43:25AM -0500 Sender: owner-freebsd-questions@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.ORG On Sun, Feb 20, 2000 at 11:43:25AM -0500, Walt Roberts wrote: > I've run out of patience and your help would be greatly, graciously > appreciated! > > Problem: Swapped ADAPTEC 1502 out to use ADAPTEC 1542C after installing > 3.3.x and can't get tar (or mount or mt) to access the EXABYTE 8200 > (scsi device 4) to read the device. > > History: Since no device drivers appeared to be available for the 1502 > and I have tarred stuff on 8 mm (DEC ULTRIX tarred files), I tried to > install the AHA-1542C board and an EXABYE-8200 (taken from the VAX) to > read the files. > > The AHA installed and appeared to be properly identified by FreeBSD at > all the right spots. During boot it tickled the exabyte numerous times > (slowly), and came up fine. > > Camcontrol dev will show the aha1542 device on scbus0 but no devices. > Camcontrol periph will show the aha1542 likewise. > Camcontrol scan will then show the exabyte-8200 and hangs at this > point. Kill -9 won't make this process go away. Only reboot does. > > Tar commands tried: > tar -tf /dev/rsa0-6 > (likewise mount and mt) Could you post the dmesg(8) output? -- Crist J. Clark cjclark@home.com To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message