Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 10 Jun 2003 17:57:13 -0700
From:      "Brent Wiese" <brently@bjwcs.com>
To:        "'TOPCAT CONSULTING'" <topcat@sk.sympatico.ca>, <freebsd-questions@FreeBSD.ORG>
Subject:   RE: very slow NIC
Message-ID:  <001e01c32fb4$65b6bf80$0a0114ac@home.bjwcs.com>
In-Reply-To: <3EE6736B.82597481@sk.sympatico.ca>

next in thread | previous in thread | raw e-mail | index | archive | help
This sounds like an auto-sense problem.

If you're hooked up to a hub, 10 half is the best you'll get. If it's a
switch, it may be setting itself full-duplex.

If its not a managed switch (you can't tell it what the ports should set
themselves to), you can try changing the settings on the card (man
ifconfig), but more than likely you're stuck.

However, its odd its 1 direction... You may just have a bad cable. Try
swapping it.

> -----Original Message-----
> From: owner-freebsd-questions@freebsd.org 
> [mailto:owner-freebsd-questions@freebsd.org] On Behalf Of 
> TOPCAT CONSULTING
> Sent: Tuesday, June 10, 2003 5:10 PM
> To: freebsd-questions@FreeBSD.ORG
> Subject: very slow NIC
> 
> 
> I have an ethernet card that just doesn't seem to be 
> performing well in both directions (in and out)....when I 
> access this NIC from another machine on the LAN, file 
> transfer is extremely fast, but when I use this machine to 
> access another machine on the LAN, I can barely get 10 kb/sec 
> out of it!
> 
> Anyway dmesg.boot reports the card as:
> 
> rl0: <RealTek 8139 10/100BaseTX> rev 0x10 int a irq 9 on pci0.13.0
> rl0: Ethernet address: 00:20:18:88:96:47
> rl0: autoneg complete, link status good (half-duplex, 10Mbps)
> 
> So, is full-duplexing not turned on or something?  How do I 
> turn full-duplexing on?  Or maybe that's not the problem?
> 
> _______________________________________________
> freebsd-questions@freebsd.org mailing list 
> http://lists.freebsd.org/mailman/listinfo/freebsd->; questions
> 
> To unsubscribe, send any mail to 
> "freebsd-questions-unsubscribe@freebsd.org"
> 
> 



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?001e01c32fb4$65b6bf80$0a0114ac>