Date: Wed, 25 Jun 2003 23:37:30 +0900 (JST) From: Hideyuki KURASHINA <rushani@bl.mmtr.or.jp> To: dickey@radix.net Cc: sos@FreeBSD.org Subject: Re: problem installing 4.7/4.8, etc Message-ID: <20030625.233730.131910749.rushani@bl.mmtr.or.jp> In-Reply-To: <20030625134950.GA24775@saltmine.radix.net> References: <20030625134950.GA24775@saltmine.radix.net>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi, >>> On Wed, 25 Jun 2003 09:49:50 -0400, Thomas Dickey <dickey@radix.net> said: > I'm setting up a new machine, and none of the current *BSD's install on it. > Linux works. The *BSD's choke during the device identification. Perhaps > someone on this list knows why. Attaching a copy of dmesg output from one > of the Linux's I installed. The *BSD's appear to be missing an interrupt > in the IDE/PCI bus hardware (about which I know little ;-) >From your attached dmesg, > PCI: Using IRQ router SIS [1039/0008] at 00:02.0 [...] > SIS5513: IDE controller on PCI bus 00 dev 15 > PCI: Found IRQ 5 for device 00:02.5 > SIS5513: chipset revision 0 > SIS5513: not 100% native mode: will probe irqs later > SiS5513 > ide0: BM-DMA at 0x4000-0x4007, BIOS settings: hda:DMA, hdb:DMA > ide1: BM-DMA at 0x4008-0x400f, BIOS settings: hdc:DMA, hdd:pio My first machine, that is about 8 years old model, has SiS 5513. It works here since I installed FreeBSD snapshot as of the end of 2003/05. atapci0: <SiS 5513 WDMA2 controller> port 0xfe80-0xfe8f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device 1.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: simplex device, DMA on primary only ata1: at 0x170 irq 15 on atapci0 SiS 5513 supports WDMA2, However, some HDDs might freeze when they detected by kernel. I *have to* type in following instruction set hw.ata.ata_dma=0 at loader prompt (or put equivalent into /boot/loader.conf) in order to disable DMA and use PIO transfer for HDDs. Recent FreeBSD 4.x would fail to boot because it does not have src/sys/dev/ata/ata-chip.c, I think. Soren, My understanding is OK, isn't it? -- rushani
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20030625.233730.131910749.rushani>